Overview
The G2 Chry/Ford/GM small bearing rear wheel bearing kit, number 30-9000, supplies the bearing and seal for rear wheel positions on small bearing axles. It includes a 6408 bearing and an 8835S seal.
The kit is matched by axle size rather than by vehicle, so measure your rear axle before installing the parts.
Key features
- Includes a 6408 bearing and an 8835S seal
- Rear wheel position
- Covers Chrysler 8.25 and 9.25 inch, Ford 8.8 inch, GM 10 bolt 8.5 inch and GM 12 bolt 8.875 inch axles
- Replaces rear wheel bearings and seal together
Choosing the right bearing kit
A rear wheel bearing kit is only half the job, since the bearing and seal must suit the housing they run in. Measure the axle housing and compare its size against the kit before buying, because small bearing axles from different makers can look similar. Replacing the bearing and seal together keeps the new bearing protected from the wear an old seal leaves behind.
Bearings usually fail from heat, contamination or wear that has been building for a while, so inspect the axle shaft, hub and bearing bore while the axle is out. Check for pitting on the bearing race, grooves in the hub surface and any sign of oil leakage. A damaged seal often means the bearing has been running with water or grit inside.
- Clean the bearing bore before pressing in the new bearing
- Use a press or proper driver to avoid cocking the bearing
- Refill the axle with the correct lubricant after the install
- Check the wheel for play after a short test drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Kit number | 30-9000 |
| UPC | 631410095432 |
| Position | Rear |
| Bearing | 6408 |
| Seal | 8835S |
| Axle sizes | Chrysler 8.25 inch; Chrysler 9.25 inch; Ford 8.8 inch; GM 10 bolt 8.5 inch; GM 12 bolt 8.875 inch |
Vehicle fitment
The kit is matched by axle size, not by vehicle year or model. The fitment grid also includes a Universal Fit entry, but a bearing must match the axle, so measure your axle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a wheel bearing and seal typically means removing the wheel, hub and axle shaft, then pressing in the new components. Support the vehicle securely on stands before working under it.
What’s included
The kit includes a 6408 bearing and an 8835S seal. Not included: the axle shaft, hub and wheel.




