Overview
The Alloy USA 35400 is a Dana 30 axle bearing with part number 35400. It is a replacement bearing for Dana 30 axle assemblies and a direct fit design for trail and road use.
Check the make, model, year and trim of your vehicle against the Dana 30 axle before installing it.
Key features
- High quality bearing
- Direct fit design
- Suited to trail and road use, per the brand
- Dana 30 axle bearing identified by part number 35400
Dana 30 bearing care
An axle bearing carries the load of the hub and wheel while letting the shaft spin with little friction. On a Dana 30 axle, the bearing sits inside the hub and is held in place by a retainer and seals. Worn bearings tend to make noise, feel loose, or run hot when driven at highway speed.
When replacing a bearing, clean the hub bore and inspect the race for pitting or heat marks before pressing the new bearing in. Use a proper press or driver so the load goes onto the correct face. Pack the bearing with fresh grease, and check the axle end play once everything is torqued. Replace seals with the bearing so grit does not enter the new unit, and replace the hub retainer parts that are often worn alongside it.
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 35400 |
| UPC | 70000370002 |
| Axle type | Dana 30 |
| Fitment type | Direct Fit |
Vehicle fitment
Fit depends on the Dana 30 axle on your vehicle, so check the axle before fitting.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The item is the bearing itself. Compare what arrives with your installation steps before starting work.






