Overview
The Flowmaster 40 Series Muffler, part number 430402, is a chambered street and strip muffler made from aluminized steel. It was the first muffler in the brand’s 40 Series line and is built for the aggressive muscle car tone Flowmaster is known for.
It is built for owners who want that exhaust note heard from inside and outside the vehicle. It is a universal fit muffler, so it is not sized for one specific year, make or model.
Key features
- Chambered design for an aggressive street and strip sound
- Centered inlet with a dual offset outlet
- 3 inch inlet and 2.5 inch outlet tube sizes
- Aluminized steel body
- Universal fit, with no specific vehicle named
Exhaust layout and fitting
A chambered muffler reduces sound with internal chambers rather than packing material, so the tone comes from how the chambers and tubes are arranged. Changing the muffler changes the sound at the tailpipe, and it can also change the drone at cruising speed, depending on how the rest of the exhaust is built.
Universal mufflers are usually fitted into the existing pipe run, which means choosing the position of the inlet and outlet before cutting. Keep the pipe straight through the muffler where possible, and avoid sharp bends right after the outlet, which can add restriction and noise.
Aluminized steel corrodes more slowly than plain steel, but road salt and trapped moisture still wear it over time. Inspect the body, welds and hangers each season, and look for pinholes, rust bubbles or loose clamps that let exhaust leak under the floor.
- Check the inlet and outlet sizes against your pipes before cutting
- Confirm clearance around the axle, fuel lines and floor
Specifications
| Brand | Flowmaster Exhaust |
|---|---|
| Part number | 430402 |
| UPC | 700042010448 |
| Muffler type | Chambered |
| Inlet location | Centered |
| Outlet location | Dual offset |
| Material | Aluminized steel |
| Tube size (inlet/outlet) | 3 inches / 2.5 inches |
Vehicle fitment
It is a universal fit muffler, so it is not built for a particular year, make or model. Fit depends on your exhaust layout, pipe diameters and underbody clearance.
It is not sized for any close vehicle model, so do not assume a fit from a similar model. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because this is a universal muffler, it is not a bolt-on replacement. Fitting it usually means cutting into the existing exhaust, matching the 3 inch inlet and 2.5 inch outlet to your pipes, and joining the sections with clamps or welds. Have an exhaust shop confirm clearance before the vehicle is driven.
What’s included
The muffler (part number 430402) is the item described. Not included: Exhaust pipe, hangers and clamps are not included, so plan to source them before the install.












