Overview
Part number 843015 is a Flowmaster Super 10 Series muffler with a short, single chamber body. It is built from 409S stainless steel and is universal fit, so the match to a given vehicle depends on your exhaust.
The Super 10 design is intended to sound close to open pipe, and it is not suited to street-driven vehicles. The Delta Flow technology inside is shared with the Super 40 and Super 44 mufflers.
Key features
- Delta Flow technology shared with the Super 40 and Super 44 mufflers
- 409S stainless steel for durability
- Short, single chamber body
- Variety of inlet and outlet configurations
Street use and exhaust sound
Exhaust mufflers control sound and back pressure, and a short single chamber design usually lets more of the engine’s tone through than a larger multi-chamber unit. That suits off-road builds where a loud, open exhaust is the goal, but noise can climb quickly on pavement. Before fitting any muffler, think about where the vehicle will run most often and whether local rules limit exhaust volume.
Muffler replacement often goes hand in hand with other work. Fresh clamps, sound hangers and a pipe in good condition help keep the new muffler from loading the old joints. Inspect the rear section for rust, cracks and loose hangers, since a worn hanger can let the body hit the frame or axle.
- Check the body for clearance under the axle
- Replace worn hangers at the same time
- Use new clamps at every joint
- Look for rust at the outlet and seams
Specifications
| Brand | Flowmaster Exhaust |
|---|---|
| Part number | 843015 |
| UPC | 700042023936 |
| Series | Super 10 (Super Ten) |
| Material | 409S stainless steel |
| Chamber design | Single chamber, short body |
Vehicle fitment
The universal listing applies, with no specific year, make or model attached. Measure your current exhaust, since inlet, outlet and hanger positions decide whether this muffler will bolt in.
Fitment is not tied to a named vehicle here. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Expect to fabricate the connection to your pipe. Mark and cut at a point that keeps the outlet clear of the rear axle and bumper, then clamp or weld the joints.
What’s included
No clamps, hangers or hardware come with it.
Not included: pipes, clamps and fittings needed to connect the muffler to your exhaust.









