Overview
The 843016 is a Super 10 Series muffler, a short single chamber design made of 409S stainless steel. It is universal fit, so it is not tied to a specific year, make or model.
Like the rest of the Super 10 family, this model uses Delta Flow technology carried over from the Super 40 and Super 44 lines. The design is aggressive, so it is intended for off-road use rather than street-driven vehicles.
Key features
- Delta Flow technology from the Super 40 and Super 44 lines
- 409S stainless steel for durability and long life
- Short single chamber body
- Inlet and outlet configurations that vary
Before you cut the pipe
Cutting into an exhaust is the step that most often goes wrong. Mark the cut so the new muffler sits level, with the outlet pointing where the tailpipe needs it. Dry-fit the assembly before welding, and check that it clears the floor, spare tire and rear suspension through the full range of travel.
Clamp joints are easier to adjust later, while welded joints last longer but cannot be undone. Use exhaust sealant only where the design allows it. After the first few drives, check each joint for leaks and look for heat marks that show a loose connection.
- Dry-fit before welding
- Keep the outlet clear of the bumper
- Check for leaks after the first heat cycle
- Recheck hangers after the first trail run
Specifications
| Brand | Flowmaster Exhaust |
|---|---|
| Part number | 843016 |
| UPC | 700042031801 |
| Series | Super 10 (Super Ten) |
| Material | 409S stainless steel |
| Chamber design | Single chamber, short body |
| Inlet/outlet | Variety of configurations offered |
Vehicle fitment
No specific vehicle is named for this muffler. The universal listing means the pipe diameter, outlet position and hanger points decide whether it works on your car.
No specific vehicle is named for this muffler. Measure the pipe diameter, outlet position and hanger points, then check the year, model and trim before ordering.
Installation notes
Plan the cut so the outlet points where your tailpipe needs it, then weld or clamp the joints. Have the exhaust checked for leaks after the first heat cycle.
What’s included
Clamps and hangers are not included with it.
Not included: pipe and connection parts to join the muffler to the exhaust.









