Overview
The Firestone Ride-Rite 7076 is a Sport-Rite air helper spring rated medium duty, with a reversible sleeve bag and a 5 inch bag diameter. Its tapered spring design provides up to 3000 lbs of leveling capacity, and the spring is universal fit. Mounting and height still need checking before use.
The spring helps keep a vehicle level, levels off-center loads, reduces suspension fatigue and reduces bottoming out. Air adjustment improves ride quality.
Key features
- Medium duty air helper spring
- Tapered spring design
- Reversible sleeve bag type
- Up to 3000 lbs of leveling capacity, per the maker
- Levels off-center loads and helps reduce suspension fatigue
- Air adjustment for improved ride quality
Setting up the air system
Air helper springs work best when the air system is set up with care. Run the air line to a clean, protected spot, use the correct fitting at the inlet, and test every connection with soapy water before putting a load on the vehicle. A small leak at the inlet can drain the spring over time and make it look like a suspension fault.
Mounting height matters as much as the spring itself. Check the clearance at full compression and full extension before you drive, because a spring that hits a bracket or tire will wear fast. Keep the mounting studs and blindnuts tight and check them after the first few trips.
- Route air lines away from heat and moving parts
- Use a gauge to set pressure in small steps
- Inspect sleeves for abrasion each time you check the mounts
- Keep a spare fitting on hand before trips
Specifications
| Brand | Firestone Ride-Rite |
|---|---|
| Part number | 7076 |
| Product line | Sport-Rite |
| Duty rating | Medium duty |
| Bag type | Reversible sleeve |
| Bag diameter | 5 inches |
| Installed height | 7 inches |
| Max extended height | 10.5 inches |
| Max compressed height | 10.5 inches |
| Air inlet size | 1/8 NPT |
| Mounting type | (1) 3/4″-16 combo stud top, (1) 3/8″-16 blindnut bottom |
| Leveling capacity | Up to 3000 lbs |
| Max air pressure | Set air pressure within the limits your installation allows, and confirm the maximum before inflating. |
| Fitment | Universal fit |
Vehicle fitment
The 7076 is a universal fit spring, so it is not tied to one year, make, model or trim. Compare the mounting stud and blindnut sizes and the heights with your vehicle before installing.
Confirm your vehicle’s year, model and trim before ordering, since no vehicle is named for this spring.
Installation notes
Connect the 1/8 NPT air inlet to your air line before testing the spring. Use the 3/4″-16 top stud and the 3/8″-16 bottom blindnut as the two mounting points. Check the 10.5 inch maximum extended and compressed heights against your travel clearance before mounting.
What’s included
Confirm the mounting hardware and air fittings you have on hand before starting the install.









