Overview
The Firestik SS-H2F is a heavy-duty stainless steel mounting spring for standard 3/8-24 threaded flags. It mounts in any hole from 3/8 inch (10mm) to 1/2 inch (13mm) on a mount, vehicle body or bracket. It is a universal fit part, not built for a specific year, make or model.
Shoppers looking for a spring mount for a safety flag or CB-style antenna will want the exact hole range and body dimensions, which are stated below. The body diameter is 0.800″ (20mm) and the mounted height is 3.16″ (80mm).
Key features
- Stainless steel spring body
- Mounts in any hole from 3/8″ (10mm) to 1/2″ (13mm)
- Body diameter 0.800″ (20mm)
- Mounted height 3.16″ (80mm)
- Accepts standard 3/8-24 threaded flags
- All mounting hardware is stainless steel
Spring tension and wear
A mounting spring works by flexing and gripping the hole it sits in, so its condition shapes how steady a flag or antenna feels on the road. Over time, repeated vibration can flatten the coils, loosen the seat in the mounting hole or wear the stainless steel at contact points. Check the spring for bends, flattened coils or discoloration at the seat after rough trails, and replace it when it no longer grips firmly.
Before buying, measure the hole and confirm the mounted height leaves enough clearance for the flag and any cable routing. A spring that seats well in a clean, deburred hole will hold better than one forced into a rough edge. Stainless steel resists rust, but the hole itself can corrode if left bare, so touch up bare metal around it when you install the spring.
- Deburr the hole edge before installing
- Check the spring seat after the first few drives
- Look for rust around the mount hole
- Replace a spring that has taken a permanent bend
Specifications
| Brand | Firestik |
|---|---|
| Part number | SS-H2F |
| UPC | 716414720020 |
| Spring body material | Stainless steel |
| Mounting hardware | Stainless steel |
| Hole size range | 3/8″ (10mm) to 1/2″ (13mm) |
| Body diameter | 0.800″ (20mm) |
| Mounted height | 3.16″ (80mm) |
| Flag thread | 3/8-24 |
Vehicle fitment
It is a universal fit part and is not built for a particular year, make or model. Compatibility depends on whether your mount, bracket or body has a suitable hole.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Mount the spring in any hole from 3/8 inch to 1/2 inch (10mm to 13mm). Measure the hole before ordering, since a hole outside that range will not take the spring.
What’s included
The mounting spring is described with stainless steel mounting hardware.
Not included: flags. The spring is designed to accept standard 3/8-24 threaded flags, which are a separate item.









