Overview
The Firestik ST4 is a stud mount that accepts standard 3/8-24 threaded Firestik flags. Its 5/8 inch (16mm) hex coupling nut is brass with a nickel-chrome plated finish, and the stud fits any hole from 3/8 inch (10mm) to 1/2 inch (13mm). It is a universal fit part.
Total height above the mount surface is 1.16″ (30mm), and all mounting hardware is stainless steel. Use the hole range and height figures below to check that the stud suits your mount or bracket.
Key features
- Accepts standard 3/8-24 threaded Firestik flags
- Mounts in any hole from 3/8″ (10mm) to 1/2″ (13mm)
- 5/8″ (16mm) hex brass coupling nut
- Nickel-chrome plated finish
- Total height 1.16″ (30mm) above the mount surface
- Stainless steel mounting hardware
Choosing a stud mount location
A stud mount puts the flag or antenna at the height and position of the hole you choose, so placement affects both visibility and clearance. Pick a spot away from doors, tailgates and overhead obstacles, and check that the height above the surface will not catch on branches or garage openings. The coupling nut takes the most handling, so tighten it firmly but avoid overtightening the threads.
The brass coupling nut with a plated finish protects the connection from weather, but plating can scratch when a nut is turned against a rough surface. Use a protective washer and take care during installation, then inspect the finish for chips that could let moisture reach the metal underneath. Stainless hardware resists rust well, though the surface around the hole still deserves a check after wet trails.
- Confirm the hole is clean and deburred before fitting
- Check the coupling nut for chips in the plating
- Re-tighten the stud after the first few trail runs
Specifications
| Brand | Firestik |
|---|---|
| Part number | ST4 |
| UPC | 716414720006 |
| Coupling nut material | Brass |
| Coupling nut size | 5/8″ (16mm) hex |
| Finish | Nickel-chrome plated |
| Hole size range | 3/8″ (10mm) to 1/2″ (13mm) |
| Total height above mount surface | 1.16″ (30mm) |
| Mounting hardware | Stainless steel |
| Flag thread | 3/8-24 |
Vehicle fitment
It is a universal fit part, so no year, make or model applies. Fit depends on the mounting hole and the flag you attach. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The stud mount comes with its coupling nut and stainless steel mounting hardware.
Not included: flags. The stud is designed to accept standard 3/8-24 threaded flags, which are a separate item.









