Overview
The Firestik II FS Series CB Antenna, model FS4-R (part number DASFS4-R), is a top-loaded CB antenna with a tunable tip. It is universal fit for autos, trucks, vans, motorcycles and ATVs. It works in a single antenna setup on a metallic ground plane, or in a dual co-phased setup on any type of material.
Firestik built the FS series on the proven features of its KW antennas and added a tuning mechanism to the top. The patented design broadens bandwidth to keep SWR lower over more channels, and the upper coil extension increases power handling.
Key features
- Tunable tip: pop off the tip and turn the adjustment screw up or down
- Patented design broadens bandwidth for lower SWR over more channels
- Upper coil extension increases power handling
- Receives NOAA emergency weather alerts and national weather broadcasts on compatible radios
- Glass fiber reinforced shaft with heavy insulated copper windings
- Rust-proof brass tip with a rubber O-ring that holds the adjuster after tuning
- Static reducing, water-tight sleeve with UV and pigment stabilizers
- Factory bench tested, with a 5 Year Limited Warranty
Mounting and ground plane tips
A CB antenna works best when the mount, ground plane and coax all do their part. A metal roof or fender often gives the antenna a usable ground plane, while a non-metallic surface may call for the dual co-phased setup. Pick a mounting spot with clear space around the antenna so nearby objects do not shift the tuning.
Tuning changes when the antenna moves, so check it again after any change to the mount, cable or vehicle body work. Keep the base contact clean and tight, and seal connections against moisture so the signal does not weaken over time. Check the shaft for cracks or loose windings after rough trail use.
- Clean the base contact before tightening the mount
- Recheck tuning after moving the antenna or coax
- Seal coax connections against water and road grime
Specifications
| Brand | Firestik |
|---|---|
| Part number | DASFS4-R |
| Model | FS4-R, Firestik II FS Series |
| Antenna type | Top-loaded, tunable tip |
| Base thread | 3/8-24 threaded base with tapered contact point |
| Shaft | Glass fiber reinforced |
| Coil | Heavy insulated copper wire |
| Tip | Rust-proof brass with rubber O-ring |
| Sleeve | Static reducing, water-tight, UV and pigment stabilized |
| Warranty | 5 Year Limited Warranty |
| Recommended coax | 18-foot Fire-Flex, #DASTS-8X18 |
Vehicle fitment
The antenna is universal fit. The single antenna setup needs a metallic ground plane, while the dual co-phased setup works on any material. It is not tied to a make, model or year.
The antenna is not vehicle-specific, so tune it on the vehicle where it is installed. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Tune the antenna after it is installed on the vehicle. Firestik says all antennas must be tuned after installation, and transmitting antennas are not plug-and-play. To tune, pop off the tip and turn the adjustment screw up or down. The tapered contact point at the 3/8-24 base works especially well with Firestik mounts.
What’s included
Check the package contents against your installation before starting.
Not included: the coaxial cable. Firestik recommends its 18-foot Fire-Flex coaxial cable, #DASTS-8X18, for this antenna.











