Overview
The TeraFlex Falcon Series 3.1 Piggyback Shock Absorber Kit (part 03-01-31-400-253) is a hydraulic piggyback shock set for 2007–2017 Jeep Wrangler (JK) Unlimited models with a 2.5 to 3.5 inch lift. TeraFlex builds the set for the Wrangler specifically, with corner-specific front and rear shocks rather than a generic shock adapted to the vehicle.
The front shock uses a horizontal reservoir and an offset upper stud to gain clearance from large tires during articulation and turning, plus clearance from the frame. The rear shock places its body and reservoir at the bottom, which helps keep rocks kicked up by the tires away from the shaft. The outboard mounting is intended for lifted vehicles with raised track bar brackets.
The damping is built from the ground up, with stability and fitment as the priorities. Confirm your lift height falls within 2.5 to 3.5 inches before ordering.
Key features
- Piggyback reservoir design, which TeraFlex says increases fluid flow by 6x over restricting reservoir hose designs
- Horizontal front reservoir for tire clearance during articulation and turning
- Offset upper stud on the front shock adds frame clearance
- Rear shock body and reservoir sit low to limit rock damage to the shaft
- Outboard mounting for lifted vehicles with raised track bar brackets
- JK-specific reservoir locations
- Stated benefits include increased vehicle stability and improved dynamic roll control
Choosing a piggyback setup
A piggyback shock moves its fluid through an external reservoir, which gives the damper more room to work than a shock with a restricted hose. On a lifted Wrangler that extra room matters most on rough trails, where the shock cycles hard over ledges and washouts. Reservoir placement is the other key point: a reservoir that sits too high can catch on brush or get hit by debris, so compare how the reservoir is positioned before buying.
When choosing a kit, match the shock to your lift height and tire size first, then think about the parts that tend to get replaced alongside it. Bushings and hardware wear as the vehicle moves through its travel, so inspect them at each oil change. Worn shocks show up as fluid leaks, a bouncy ride on pavement, or a clunk at the end of the stroke.
- Inspect reservoir hoses and fittings for seepage
- Check upper and lower mounts for play
- Re-torque mounting bolts after the first few trail runs
Specifications
| Brand | TeraFlex |
|---|---|
| Product line | Falcon Series 3.1 piggyback |
| Part number | 03-01-31-400-253 |
| UPC | 843885040217 |
| Lift range | 2.5–3.5 inch |
| Shock type | Hydraulic piggyback |
| Front shock | Horizontal reservoir, offset upper stud |
| Rear shock | Reservoir at bottom |
| Sold as | Set |
Vehicle fitment
The listed fitment covers the 2007–2017 Jeep Wrangler (JK) Unlimited, with the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims included.
Models outside that group, such as the JL generation and non-Unlimited JK bodies, are not in the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The kit is sold as a set. Check the package contents against your installation before starting.









