Overview
The Fabtech FTS743 is a U-bolt kit from the brand’s suspension block line, with part number FTS743 and UPC 674866034358. It comes as a kit with eight thick flat washers, eight tall Nylock nuts and four U-bolts. Check fit for your vehicle before ordering.
Key features
- Eight thick flat washers
- Eight tall Nylock nuts
- Four U-bolts in the kit
Suspension block mounting basics
Suspension block mounting uses a block between the axle and the springs, with U-bolts clamping the assembly together. The block changes the position of the clamp, so the U-bolt legs and spring seat need to line up. When the block thickness changes, the clamp length and the axle height change with it.
Before assembly, check the block faces for cracks, corrosion or flattened surfaces, and replace any worn parts. Install the nuts evenly and torque them to the value for your setup. Recheck the clamp after the first few miles of driving, since parts seat and nuts can settle during early use.
Keep mounting surfaces clean and free of paint or grease that can cause slip under load. A clean, square fit gives the clamp its best chance of holding.
- Check block faces for cracks
- Match clamp length to the block
- Retorque nuts after the first drive
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS743 |
| UPC | 674866034358 |
| Format | Kit |
| Hardware | Eight thick flat washers, eight tall Nylock nuts, four U-bolts |
Vehicle fitment
Fit depends on your axle and spring setup, and no year, model or chassis code is named for this kit. Check your setup before fitting it.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The kit contains eight thick flat washers, eight tall Nylock nuts and four U-bolts.







