Overview
The Fabtech FTS728 is a U-bolt kit from Fabtech’s suspension block and U-bolt range. The set includes eight Nylock tall nuts, eight thick flat washers and four U-bolts. Check fit for your vehicle before ordering.
Key features
- Tall Nylock nuts
- Thick flat washers
- Direct fit listed
Sizing the clamp set
A U-bolt clamp only works when its width, diameter and thread length suit the axle tube and spring pack. Tall Nylock nuts are chosen because they resist loosening under vibration, which helps when the clamp is used on rough roads. Thick flat washers spread the clamp load so the spring and plate are not crushed.
Before fitting, clean the threads and inspect the axle seat for rust or flattened spots. Keep the nuts evenly tightened, working across both sides, and retighten after the first few drives. If the vehicle is used for towing or hard off-road runs, check the clamp more often, since repeated shock can loosen even a correct installation. Keep a note of the torque value from your axle setup for later checks.
- Measure the axle tube before ordering
- Check spring pack thickness
- Replace bent or stretched U-bolts
- Recheck nut torque after first drives
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS728 |
| UPC | 674866004948 |
| Format | Kit |
| Hardware | Four U-bolts with eight tall Nylock nuts, plus thick flat washers |
Vehicle fitment
Confirm fit for your suspension and mounting before installing, since the year, model and trim are not yet matched to this kit.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Kit contents are four U-bolts plus eight tall Nylock nuts and eight thick flat washers, with nothing else listed.




