Overview
The Fab Fours DR13-D2952-1 is a Vengeance Series pre-runner front bumper for 2013 to 2018 Ram 1500 trucks, made from 11 ga. U.S. steel with a two-stage black powder coat.
The pre-runner guard version weighs 75 lb, ten pounds above the no guard version. The center mount takes a Rigid Industries 20-inch LED light bar, the sides take two 2×2 Dually lights, and a lower cutout moves air to the intercooler. Parking sensors may read the ground on a non-lifted truck because of the bumper’s angles, since sensor setup was tested on lifted trucks.
Key features
- Pre-runner guard version at 75 lb
- Center mount for a Rigid Industries 20-inch LED light bar
- Side mounts for two 2×2 Dually lights (lights not included)
- Lower cutout that provides airflow to intercoolers
- Complete bolt-on bumper with brackets tied to the frame
- Two-stage black powder coat
- 11 ga. U.S. steel
- Made in the USA
Living with a pre-runner guard
Front weight is the first thing to think about with a pre-runner guard. Added mass on the nose affects steering feel, braking distance and tire wear, and it reduces the load room the truck can carry at the front. Many owners review their brakes and suspension after adding a heavy front bumper, since those parts do more work with extra weight.
Guard protection works best when the mounts stay tight. Rock and brush strikes can loosen brackets over time, so check the bolts after rough days and look for cracks at welds. Keep the lower intercooler cutout clear of mud and debris, and check the light wiring before each trip. A bumper that has been hit should be inspected before it goes back into regular use.
- Review braking after adding front weight
- Recheck guard bolts after rough trails
- Keep the lower cutout free of mud
- Inspect welds after any hard impact
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | DR13-D2952-1 |
| UPC | 5810110857 |
| Type | Vengeance pre-runner front bumper |
| Position | Front |
| Width | Full |
| Material | Steel, 11 ga. U.S. steel |
| Finish | Two-stage black powder coat |
| Weight | 75 lb with pre-runner guard |
| Fit type | Direct fit |
| Light mounts | Included |
| Winch mount | Not included |
| D-ring mounts | Not included |
Vehicle fitment
This bumper is for the 2013 to 2018 Ram 1500.
The list does not reach the 2012 and older Ram 1500 or the Ram 2500 and 3500. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The brackets tie directly to the frame, so the install is bolt-on. Any added lights should be wired with a fused relay, and the lower cutout should be kept clear so it can pass air to the intercooler. Check how parking sensors read at the truck’s ride height after installation.
What’s included
- Vengeance pre-runner front bumper in black powder coat
- Frame-mounting brackets
Not included: The LED light bar, Dually lights, a winch mount and D-ring mounts.
















