Overview
The Fab Fours Stubby Front Base Bumper in bare steel, part number JK07-B1853-B, is a winch-ready front bumper with Hi-Lift Jack points for the 2007–2018 Jeep Wrangler JK, 2-door and 4-door.
Fab Fours builds the stubby bumper to provide maximum tire clearance. The bare steel version accepts winches up to 10,000 lb or smaller and takes the WARN Power plant, with 3/4 inch D-ring mounts included. Cutouts are shaped for the factory fog lights. An optional 90mm Fab Fours fog light kit, JKST-LA, is available. A 2-stage matte black powder-coated version of this bumper carries a -1 part number.
Key features
- Designed for maximum tire clearance
- Hi-Lift Jack points
- Winch ready: accepts winches up to 10,000 lb or smaller
- Accepts the WARN Power plant
- Cutouts for factory fog lights
- 3/4 inch D-ring mounts
- 3/16 steel, bare finish, made in the USA
Rust protection on bare steel
Bare steel bumpers rely on the owner for corrosion control. Steel exposed to road salt, wet mud and stream water will begin to rust at scratches, weld seams and bolt holes first. A bare finish can be painted or coated after installation, and a primer suited to bare metal helps the topcoat grip the surface.
Routine cleaning keeps the surface in better condition. Rinse the bumper after trail use in wet or salty conditions, dry it fully, and inspect the lower edges and the winch mount area. Surface rust that is caught early is easy to sand and touch up, while deep pitting may call for a repair before the bumper is used for recovery.
- Clean off salt and mud after wet or winter use
- Touch up scratches before rust spreads
- Check weld seams and bolt holes periodically
- Repaint or coat the bumper after fitting
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | JK07-B1853-B |
| UPC | 70000513738 |
| Position | Front |
| Width | Stubby |
| Material | Steel, 3/16 |
| Finish | Bare (matte black powder coat is -1 instead of -B) |
| Winch rating | Up to 10,000 lb or smaller |
| D-ring mounts | 3/4 in, included |
| Winch mount | Included |
| Light mounts | Included |
| Fit type | Direct fit |
Vehicle fitment
The JK07-B1853-B is a direct fit for the 2007–2018 Jeep Wrangler JK, in both 2-door and Unlimited models.
The stubby base bumper does not fit the TJ or LJ Wrangler, or the newer JL. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Since the finish is bare steel, rust protection is up to the installer.
What’s included
- Stubby base front bumper in bare steel
- Winch mount
- 3/4 inch D-ring mounts
Not included: The optional 90mm fog light kit (JKST-LA) and a winch.









