Overview
The DrawTite 41531 is a Class III/IV Max-E-Loader rear trailer hitch for the 2004–2006 Jeep Wrangler LJ and the 1997–2006 Jeep Wrangler TJ. It adds a 2 inch by 2 inch receiver to the rear of the vehicle for a trailer ball mount or other rear receiver accessories. It is rated for 3500 lbs gross trailer weight and 300 lbs tongue weight.
The Max-E-Loader is built from welded construction and finished in black powder coat. The hitch spreads the towing load across the vehicle frame and is built to fit the specific vehicle without adapters. It carries a limited lifetime warranty, and the install time is 15 minutes.
Key features
- Class III/IV rating for trailer loads up to 3500 lbs GTW
- All-welded construction
- Towing load distributed over the frame
- Black powder coat finish
- No drilling required
- Install time listed at 15 minutes
- Limited lifetime warranty from DrawTite
Jeep Wrangler towing basics
A rear receiver adds weight behind the axle and changes how a Wrangler handles on turns, grades and rough trails. Pick a trailer load that keeps the rear end settled, and keep speeds moderate with a loaded trailer. Check the tire pressure and brakes before each tow, since the added load stresses both.
Trailer accessories follow the receiver. A ball mount should match the 2 inch receiver opening and the coupler size. Use a hitch pin with a clip so the mount cannot work loose. A cargo carrier or bike rack adds leverage on the receiver, so watch for movement after each trip.
Older Jeep frames can show rust near the mounting points. Before fitting a receiver, look at the frame rails and the area behind the bumper, and clean and treat any corrosion. After the first few trips, recheck the hardware and look for cracks in the receiver tube or welds.
Specifications
| Brand | DrawTite |
|---|---|
| Part number | 41531 |
| UPC | 742512415315 |
| Position | Rear |
| Weight class | Class III/IV |
| Receiver size | 2 inches x 2 inches |
| Gross trailer weight | 3500 lbs |
| Tongue weight | 300 lbs |
| Finish | Black powder coat |
| Construction | All-welded |
| Fitment type | Direct fit |
| Fits with roll pan | No, does not fit with a roll pan |
| Install time | 15 min |
Vehicle fitment
It is a direct fit for the 2004–2006 Jeep Wrangler (LJ) Unlimited and Unlimited Rubicon, and for the 1997–2006 Jeep Wrangler (TJ) in the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
Two-door LJ models and Wrangler YJ, JK and JL generations are outside this fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The hitch requires no drilling, so it mounts without new holes in the frame. Because it does not fit with a roll pan, confirm whether your vehicle has one before choosing this receiver. Support the vehicle on jack stands rather than a jack alone when working underneath.
What’s included
Check the packaging to confirm which hardware is included before installing.
Not included: trailer ball, ball mount, hitch pin and clip, and any wiring harness would need separate parts.














