Overview
The DrawTite Class III/IV ball mount in black, part number DRA2953, is an all-steel drop mount with a 4 inch drop. It uses a 2 by 2 inch shank and a 1 inch ball hole.
The 4 inch drop is the main sizing point for lifted trucks towing trailers that sit lower. The mount is a universal fit part, so match the Class III/IV rating and receiver size to your own tow setup.
Key features
- 4 inch drop
- All-steel construction
- 2 by 2 inch shank
- 1 inch ball hole
- Black finish
Choosing the right drop
A lifted truck raises the receiver, so a trailer coupler that sits lower creates a larger gap. A drop mount lowers the ball to close that gap, but the gap should be measured on your own setup rather than estimated. Too much drop leaves the trailer tilted, and too little leaves the hitch riding high, so check both heights with the trailer on level ground.
Look over the welds and the shank for cracks or bends after rough trail use, since a lifted setup often takes more impact. Re-check the ball nut and hitch pin after the first few tows, and keep the pin clip in place at all times.
- Measure receiver height with the truck level
- Recheck the gap after any suspension change
Specifications
| Brand | DrawTite |
|---|---|
| Part number | DRA2953 |
| Hitch class | Class III/IV |
| Drop | 4 inch |
| Shank size | 2 inch by 2 inch |
| Ball hole size | 1 inch |
| Material | Steel |
| Finish | Black |
| Fitment | Universal Fit |
Vehicle fitment
No vehicle fitment is listed. The mount is Universal Fit, so it is not built for one year, model or trim, and the 4 inch drop has to match the height gap between your receiver and trailer.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the receiver height and the trailer coupler height, then confirm the 4 inch drop closes that gap before any towing.
What’s included
The black drop ball mount, part number DRA2953.









