Overview
The Daystar KG09120 is a 2-inch lift for four-wheel-drive Chevrolet Silverado and GMC Sierra 2500 HD and 3500 trucks, sold as part number DAYKG09120. It fits 2001 through 2010 models in the 2500 HD and 3500 versions, including the 2007 Classic trucks. The front lift comes from the factory torsion bar keys, and the rear lift comes from lift blocks and U-bolts.
The final ride height is not fixed. It depends on the torsion bar adjustment, the vehicle’s age and use, and several other factors. The kit works with orange, green or white factory torsion bar keys, so the existing keys stay in use.
Key features
- 2-inch lift for 4WD 2500 HD and 3500 trucks
- Front lift set through the factory torsion bar keys
- Rear lift from lift blocks and U-bolts
- Compatible with orange, green and white factory torsion bar keys
- Ride height adjusted through the torsion bar setting
Before you buy
A torsion bar front suspension is adjusted by changing how the bars are set, so the final front height is a setting rather than a fixed spacer. The rear relies on the leaf springs and the lift blocks, which change where the axle sits. Because the two ends are adjusted separately, one side can end up higher than the other if the front is set without checking the rear.
Heavier loads, large tires and a worn front end all change the result. Before the job, look at the condition of the factory torsion bar keys, the ball joints and the tie rod ends, since these are often checked or replaced during the same install. Plan to recheck the driveline angles and the alignment after the truck has been driven for a short while.
- Check the torsion bar keys for wear before setting the front height
- Inspect ball joints and tie rod ends during the install
- Recheck U-bolt tightness after the first few drives
Specifications
| Brand | Daystar |
|---|---|
| Part number | DAYKG09120 |
| Lift size | 2 inches |
| Front lift method | Torsion bar keys |
| Rear lift method | Lift blocks and U-bolts |
| Compatible factory torsion keys | Orange, green or white |
| Drive type | 4WD |
| Fitment type | Direct fit |
Vehicle fitment
It fits 2001 to 2010 Chevrolet Silverado 2500 HD models and 2001 to 2006 Silverado 3500 models, along with the 2007 Classic 2500 HD and 3500 versions and the 2007 to 2010 Silverado 3500 HD. The same years apply to the GMC Sierra 2500 HD and 3500 models, across the Base, LS, LT, LTZ, WT, SL, SLE and SLT versions.
Confirm fit for 2011 and later Silverado and Sierra 2500 HD and 3500 trucks before ordering, since those years fall outside the coverage above.
Installation notes
The front height is set by the torsion bar keys, so the final front height depends on how the keys are adjusted. Set the front first, then check the rear lift blocks and U-bolts. Check the driveline angles and the alignment once the ride height has been set.
What’s included
The kit includes the lift blocks and U-bolts used for the rear lift, along with the components Daystar uses to raise the front through the torsion bar keys.
Not included: The factory torsion bar keys. The kit is made to work with the orange, green or white keys already on the truck.









