Overview
The Daystar KJ60010 is a 0.5 inch lift front Super Shackle set, sold as a pair, for the 1987–1995 Jeep Wrangler (YJ). It raises the front suspension half an inch while replacing the factory shackles with a heavier-duty part.
Daystar builds these Super Shackles from heavy-duty plate steel with a fully welded center bar. That bar helps reduce deflection and axle shift during cornering and articulation, which matters most in off-road driving. Greasable bolts and bushings are not included with this part number.
Other versions of this shackle are offered for stock replacement height or up to 2-1/2 inch of lift. Choose this 0.5 inch set when that lift height is the one you need.
Key features
- 0.5 inch lift for the front suspension
- Heavy-duty plate steel construction
- Fully welded center bar that Daystar says reduces deflection and axle shift
- Heavier-duty construction than factory stamped shackles
- Zinc plated finish
- Sold as a pair
- Covered by a limited lifetime warranty
Choosing a lift height
A front shackle lift raises the body relative to the axle, which changes spring angles and how the suspension handles bumps. Before buying, decide whether you need a small lift for clearance or a stock replacement for worn factory parts, since the two needs call for different shackles. Lift height also affects steering geometry and the length of brake lines and bump stops, so consider the whole front end.
Related parts often get replaced in the same job. Check the bump stops for contact after the lift, and inspect the front brake lines for stretch. Worn spring bushings and frame mounts are easier to address during the install than afterward, when the springs are already loaded.
- Check bump stop clearance after installation
- Inspect brake lines for stretch
- Recheck the front alignment after the lift
Specifications
| Brand | Daystar |
|---|---|
| Part number | KJ60010 |
| UPC | 814423011310 |
| Lift height | 0.5 inch |
| Position | Front |
| Construction | Heavy-duty plate steel with fully welded center bar |
| Finish | Zinc plated |
| Quantity | Sold as a pair |
| Greasable bolts and bushings | Not included |
| Warranty | Limited lifetime |
Vehicle fitment
Daystar lists KJ60010 as a direct fit for the 1987–1995 Jeep Wrangler (YJ) in the Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
Coverage is limited to first-generation YJ Wranglers. The TJ, LJ, JK and JL Wrangler generations and the Cherokee XJ are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because a shackle lift changes suspension geometry, have driveline angles and front alignment checked after the new shackles are installed. Support the vehicle securely on jack stands before removing the factory shackles.
What’s included
The set is sold as a pair of front shackles.
Not included: greasable bolts and bushings.


















