Overview
The Dana Spicer 37299 is a lower king pin for front Dana 60 and Dana 61 axles. It bolts to the bottom of the knuckle and is sold for a single side only.
This lower pin is a closed knuckle part. Confirm the axle type before fitting it, since the axle matters more than the universal fit label.
Key features
- Lower king pin for front Dana 60 axles
- Bolts to bottom of knuckle
- Single side only
- Part number 37299 from Dana Spicer
Knuckle and pin checks
A lower king pin carries the bottom of the knuckle, so wear here shows up as play at the bottom of the tire, uneven tread or a knocking sound over bumps. Before fitting a new pin, inspect the bottom knuckle bore, the bolt holes and the mounting face. Any elongated holes or scoring need correction before the new pin can seat evenly.
Because the pin bolts to the bottom of the knuckle, mounting hardware and torque procedure matter. Use new fasteners if the old ones show stretching or corrosion, and clean the mating faces so the pin sits flat. Check the opposite side for the same wear, since the two sides usually show similar miles. Keep the old pin for comparison during installation, and recheck the bolts after a short drive.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 37299 |
| UPC | 23913256371 |
| Axle location | Front |
| Axle types | Dana 60, Dana 61 |
| Mounting | Bolts to bottom of knuckle |
| Side | Single side only |
| Fitment label | Universal fit |
Vehicle fitment
No vehicle-by-vehicle fitment list is available. The stated axle types are Dana 60 and Dana 61, so confirm the axle on your truck before installing. The universal fit label is secondary to that check.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit mounts to the bottom of the knuckle, so check the mounting face against your knuckle before installing.
What’s included
One lower king pin. No seals, bearings or hardware are named with it.









