Overview
The Curt Manufacturing CRT56181 is a powered converter wiring T-connector for the 2013–2017 Chevrolet Traverse in LS, LT, LTZ and Premier trims. It is a 3-wire system that plugs into the factory harness, with a listed install time of 45 minutes.
Key features
- Powered converter type
- 3-wire system
- Plugs into the factory harness
- Includes a 4-pin connector
- Install time listed at 45 minutes
Powered converters and lighting
A powered converter sits between the factory harness and the lamp, adjusting the signal so the lamp responds correctly. This matters most when a lamp type or added accessory changes the electrical load the vehicle expects. A converter can keep turn and brake functions working as intended, but it depends on a clean ground and a properly seated plug to do its job.
When choosing a converter, think about the lamps and any trailer lighting you plan to run. Check the wiring on both sides, and make sure the converter matches the lamp configuration. After installation, test each function and watch for flicker or slow blinking, which can signal a ground or contact problem rather than a converter fault.
- Match the converter to your lamp configuration
- Check ground and plug seating first
- Test turn, brake and tail functions after install
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT56181 |
| Type | Powered converter |
| Wiring system | 3-wire |
| Install time | 45 min |
| Included | 4-pin connector, dust cap, ground wire with self-tapping screw |
Vehicle fitment
It fits the 2013–2017 Chevrolet Traverse in LS, LT, LTZ and Premier trims.
Traverse years before 2013 and after 2017 are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plan on the 45 minute install Curt lists. The ground wire uses the supplied self-tapping screw.
What’s included
Kit contents are a 4-pin connector, a dust cap and a ground wire with self-tapping screw.









