Overview
The CURT 51522 is a quick plug brake control adapter harness. It lets a brake controller plug directly into the vehicle’s power system through an original equipment connector, so the controller can be installed without splicing into the wiring.
One plug fits the vehicle’s original equipment socket, and the other connects to any Curt brake controller. The socket on your vehicle has to match the harness, so compare it before buying.
Key features
- Quick plug design for brake controller installation
- Original equipment connector plugs into the vehicle’s power system
- Connects to any Curt brake controller
- Two feet of wire
- Slit loom sleeve keeps the wires protected and contained
Testing the brake controller setup
A brake controller sends power to the trailer brakes when the tow vehicle slows down, so it must be set correctly for the trailer’s weight and braking needs. After installing the harness, test the setup on a flat, empty road at low speed. Apply the controller manually to confirm the trailer brakes engage smoothly, then adjust the output in small steps and retest until the stop feels balanced.
Keep the harness routed through the slit loom sleeve, away from hot exhaust parts and moving suspension components. Recheck the plugs after the first few trips, since vibration can loosen a connection that seemed secure at installation. If the controller shows an error, check the socket and plug seating before replacing any part.
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT51522 |
| Connectors | Original equipment socket plug and Curt brake controller plug |
| Wire length | Two feet |
| Wire protection | Slit loom sleeve |
| Fitment type | Matched to the vehicle’s original equipment socket |
Vehicle fitment
Confirm that the original equipment socket matches your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The harness installs in less than 10 minutes. Snap the plug marked for the original equipment socket into the vehicle’s socket, then connect the other plug to a compatible Curt brake controller. Route the slit loom sleeve over the wires to keep them protected.
What’s included
The harness includes the original equipment socket plug, the brake controller plug, two feet of wire and a slit loom sleeve.
Not included: The brake controller is not part of this harness and must be purchased separately.









