Overview
The Curt 51457 is a brake control adapter harness, a wiring piece used in trailer brake control setups. It comes with a quick plug connector and is listed in bulk packaging. Check the connector against your brake controller and tow vehicle wiring before using it.
Key features
- Brake control adapter harness
- Quick plug connector
- Bulk packaging
Wiring a brake controller harness
A brake control adapter harness sits between the brake controller and the tow vehicle wiring, so its job is to carry the signal without loss. The quick plug connector makes it easier to connect and disconnect, but the connection still needs to be clean and fully seated. Routing matters too: keep wire away from exhaust heat, sharp edges and moving parts.
Before connecting, compare the plug and wire layout with your controller and vehicle. Use strain relief where the harness leaves the connector, and check each connection after the first few trips for looseness or chafing. Protect exposed contacts from water and road salt, since corrosion can cause intermittent brake signal faults.
- Check the plug matches your controller
- Route away from heat and moving parts
- Re-check connections after first trips
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | 51457 |
| UPC | 612314514571 |
| Connector | Quick plug |
| Packaging | Bulk |
Vehicle fitment
This harness is not tied to one vehicle. Confirm the plug and wire layout match your brake controller and tow vehicle wiring before connecting.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
No wiring steps are given for this harness, so follow the instructions for your brake controller and tow vehicle.
What’s included
Check the number of harnesses in each pack against your project before buying.









