Overview
The Currie CE-9112 is a 2 inch weld-on Johnny Joint rod end for fabricators and suspension builders making their own control arms. It has no vehicle fitment and is universal fit, so it suits custom arms rather than a specific model.
Currie cites 30 degrees of free movement in any direction, versus 22 degrees for a typical heim joint. The bushings are a high-density urethane that Currie calls tough 88, and they encase the inner ball. The center ball is heat-treated steel, cross-drilled for thru-bolt lubrication, in a 2 5/8 inch mounting width with a 9/16 inch thru-bolt hole. The outer shell is .180 inch DOM tubing with heat-treated steel retaining washers.
Key features
- Weld-on design for custom arms and brackets
- Urethane bushings in a high-density formulation
- Heat-treated steel center ball, cross-drilled for lubrication
- 9/16 inch thru-bolt hole
- Serviceable joint
- Greasable bolt, nut and washers included
Welding and layout tips
A weld-on joint is only as good as its position. Set the joint in the arm or bracket first, check the pivot path through full travel, and tack it before final welding so that the joint is not pulled out of alignment by heat.
Heat is the main risk. Urethane bushings and grease do not tolerate welding heat well, so keep the joint cool with frequent pauses and, where possible, weld away from the bushing area. Let the joint cool fully before any grease or bolt is installed.
After welding, check the joint for free movement and confirm the greasable bolt runs through the hole without binding. Inspect the welds for cracks once the arm has been in use for a short time.
- Plan the pivot path before tacking
- Keep heat away from the bushings
- Check movement after the weld cools
Specifications
| Brand | Currie |
|---|---|
| Part number | CE-9112 |
| UPC | 70000162042 |
| Joint type | Weld-on joint kit, DOM |
| Mounting width | 2 5/8 inch |
| Thru-bolt hole | 9/16 inch |
| Bushings | Urethane, tough 88 |
| Center ball | Heat-treated steel |
| Outer shell | .180 inch DOM tubing |
| Retaining washers | Heat-treated steel |
| Serviceability | Serviceable |
| Thread direction | Not applicable |
Vehicle fitment
The joint is universal fit for custom arms and brackets, so it is not built for a specific make or model. Confirm your bracket and arm suit the joint before welding.
Check the 2 5/8 inch mounting width and 9/16 inch thru-bolt hole against your bracket before welding. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a weld-on joint, so it is welded to the arm or bracket rather than bolted. The greasable thru bolt, nut and washers are included for the pivot, so plan the weld position before setting the joint.
What’s included
A Johnny Joint with a 9/16 inch greasable bolt, nut and washers.
Not included: the bracket or arm the joint is welded into.









