Overview
The Crown Automotive front hub assembly, part 53007449, is a ball bearing type front hub. It fits the 1990–1999 Jeep Cherokee XJ, the 1993–1998 Jeep Grand Cherokee ZJ, the 1997–1999 Jeep Wrangler TJ and the 1990–1995 Jeep Wrangler YJ.
The existing hub bolts are reused, so the original hardware is part of the installation. This hub is a front position unit only.
Key features
- Ball bearing type front hub
- Fits XJ, ZJ, TJ and YJ models listed in the fitment.
- Front hub assembly
- Direct fit replacement
Signs the hub is worn
A front hub carries the wheel bearing and the mounting face for the brake parts, so wear in the hub shows up as wheel movement and noise. A worn bearing often makes a low humming or growl that changes with speed and steering load. Jack up the front end, grip the tire at the top and bottom, and rock it. Play felt at the hub, rather than in the steering linkage, points to a hub problem.
Ball bearing hubs on older Jeep front axles are often replaced in pairs, so check the opposite side for similar wear before deciding what to order. Wheel bearings, seals and brake components are usually inspected at the same time. Clean the mounting face before installing so the wheel sits flat against the hub.
- Grease or fluid leaking past the seal
- Uneven tire wear on one front corner
- Play felt when the tire is rocked
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 53007449 |
| Manufacturer number | CRO53007449 |
| UPC | 848399017946 |
| Position | Front |
| Bearing type | Ball |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1990–1999 Jeep Cherokee (XJ), the 1993–1998 Jeep Grand Cherokee (ZJ), the 1997–1999 Jeep Wrangler (TJ) and the 1990–1995 Jeep Wrangler (YJ).
The 1987–1989 YJ and the 1984–1989 XJ fall outside these years. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Reuse the existing hub bolts and keep the original hardware when fitting the hub.
What’s included
One front hub assembly.
















