Overview
The Omix-ADA 16705.08 Hub Assembly is a front hub that fits either the driver or passenger side. It fits the 2000-2001 Jeep Cherokee XJ and the 2000-2006 Jeep Wrangler TJ.
It is a direct OE replacement built to the original specifications, supplied as a complete hub assembly for the front position.
Key features
- Driver or passenger side front position
- Complete hub assembly
- Direct OE replacement built to original specifications
Fitting a complete hub
A complete hub assembly arrives with the bearings and seals already in place, which removes the step of packing grease and setting bearing preload on the bench. Before removing the old hub, support the vehicle securely, remove the wheel, and disconnect the brake caliper and ABS sensor wiring so the parts can be moved clear of the spindle. Note how the old hub is bolted so the new one goes in the same way.
Clean the spindle and the hub mounting face of rust and dirt, since debris can cause the hub to sit crooked and wear the bearings early. Torque the fasteners to the specification in your service information, and recheck them after a short drive. Inspect the brake rotor for runout and the wheel studs for damage while the hub is off.
- Replace worn wheel studs as needed
- Check the ABS sensor ring for damage
- Hang the brake caliper so the hose is not stressed
- Recheck torque after the first miles of driving
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16705.08 |
| Manufacturer number | OAI16705.08 |
| UPC | 804314133856 |
| Position | Front, driver or passenger side |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2000-2001 Jeep Cherokee (XJ) and the 2000-2006 Jeep Wrangler (TJ).
Confirm fit for your vehicle’s year, model and trim before choosing this hub.
What’s included
One front hub assembly.









