Select your vehicle

Crown Automotive Rear Axle Hub – J0912647

Crown Automotive

$83.52In stock
Buy on Amazon

See similar parts on Amazon

Price and availability as of Nov 18, 2026 9:20 AM MST, from Amazon.com, and subject to change. The Amazon listing has the current details.

Check out with your Amazon account. Amazon handles delivery and returns.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Rear axle hub for Dana 53 rear axle
  • Fits driver or passenger side rear
  • Fits 1950–1955 Willys 1-Ton
  • Crown Automotive part number J0912647

Description

Overview

The Crown Automotive Rear Axle Hub, part J0912647, is a rear hub for the Dana 53 rear axle. It fits the driver or passenger side rear position and fits the 1950–1955 Jeep Willys 1-Ton.

Because the hub is built for the Dana 53, the axle type is the first thing to confirm before choosing this part. Confirm the axle on your vehicle before ordering.

Key features

  • Rear axle hub for the Dana 53 axle
  • Driver or passenger side rear position
  • Direct fit replacement

Before you install a hub

A rear hub carries the wheel bearing and mounts to the axle flange, so the most important check is that the axle matches the hub. A hub built for a different axle will not seat correctly even if the bolt pattern looks similar. Measure the axle end where the hub sits and compare it against the old part before ordering.

Hub replacement usually goes with a bearing inspection, a new seal and fresh bearing grease. Old bearings that have run loose can damage the seat of a new hub, so check for play at the wheel and feel for roughness when turning by hand. Replacing a worn seal at the same time avoids pulling the hub again soon after installation.

  • Check the axle type before ordering
  • Inspect bearings and seals while the hub is off
  • Tighten fasteners to the vehicle’s specification

Specifications

Brand Crown Automotive
Part number J0912647
Manufacturer number CROJ0912647
Position Rear, driver or passenger side
Axle Dana 53
Fitment type Direct fit

Vehicle fitment

It fits the 1950–1955 Jeep Willys 1-Ton.

Other Willys years and the CJ and Wrangler models are not covered. Confirm your vehicle’s year, model and trim before choosing this part.

What’s included

One rear axle hub.

Fitment

VehicleYearsTrims
Jeep Willys 1-Ton1950–1955All

Use “Select your vehicle” at the top of the page to check this part against your vehicle.

Questions & Answers

Does the J0912647 hub fit a 1952 Willys 1-Ton?

Yes. It fits the 1950–1955 Jeep Willys 1-Ton, so a 1952 model falls within that range. It is a rear hub for the Dana 53 axle.

Is this hub for a front axle?

No. It is a rear hub, installed on the driver or passenger side of the rear axle, so it is not a front hub.

Which axle is this rear hub made for?

It is made for the Dana 53 rear axle. Confirm the axle on your vehicle before fitting this hub, since a rear hub for another axle is a different part.

Should the wheel bearing be replaced with the hub?

Often yes. If the bearing shows play, roughness or heat marks, replacing it alongside the hub avoids a second teardown. Check the old bearing before deciding, and confirm its size against the new hub.

Ready to order?

Order this part on Amazon and check out with your Amazon account. Amazon handles delivery and returns.

Buy on Amazon