Overview
The Crown Automotive J5758964 is a 16-gauge steel replacement fender for the front right position on classic Jeep models. It fits the 1972–1983 Jeep CJ5, the 1972–1975 Jeep CJ6, the 1976–1986 Jeep CJ7 and the 1981–1985 Jeep Scrambler.
Front fenders are a common rust repair panel on older Jeeps, and this steel panel suits owners replacing a damaged or corroded front fender. It comes primed with a rust inhibitor only, so it needs priming and painting before it is finished. Professional installation is advised.
Key features
- 16-gauge steel construction
- Primed with a rust inhibitor for rust prevention only
- Passenger side, front right position
- Direct fit for the CJ and Scrambler models below
- Replacement steel body panel for CJ-series and Scrambler Jeeps
Priming before paint
A rust inhibitor primer is a starting point, not a finished coat. On an older Jeep, the front fender sits in a spot that collects dirt and moisture, so the primer has to bond well to the steel and to the topcoat that follows. Scuff the surface, wipe away oil and dust, and confirm the primer is compatible with the paint system you plan to use.
Before the panel is bolted on, look at the inner wheel arch, the seam at the cowl and the bolt holes for any surface rust. Light rust can be cleaned back to bright metal and primed again. Deeper rust usually calls for cutting and patching before the new fender goes in, otherwise moisture can get trapped behind the panel.
Give the primer time to cure fully before fitting or handling the panel too much, and keep the bare edges covered during the trial fit.
- Scuff the surface before topcoat
- Clean oil and dust from the bolt holes
- Inspect the inner wheel arch for rust
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J5758964 |
| UPC | 848399066418 |
| Material | Steel |
| Gauge | 16-gauge |
| Finish | Primed with rust inhibitor only |
| Position | Front Right |
| Location | Driver Side |
| Fitment type | Direct Fit |
Vehicle fitment
It fits these vehicles:
- 1972–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1972–1975 Jeep CJ6 (Base)
- 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade)
- 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
Wrangler YJ and later Jeep models are outside the fitment above. Confirm which side this panel fits against your vehicle before ordering, and confirm your vehicle’s year, model and trim before ordering.
Installation notes
Professional installation is recommended. Because the panel comes with rust inhibitor only, prime it before painting. Minor imperfections can occur in transit, and claims for freight damage must be placed directly with the freight carrier.
What’s included
One replacement steel fender panel.
Not included: Check the mounting hardware and paint against your installation before starting.









