Overview
The Crown Automotive 55013515 is a replacement steel front fender for the driver side (front left) of the 1987–1995 Jeep Wrangler YJ. It is black primer coated, which means it needs more preparation before it is painted.
Several YJ trims are covered, including Base, Islander, Laredo and Sahara. Renegade models are excluded, so the trim match needs a close look.
Key features
- Steel front left fender for the driver side
- Black primer coated surface
- Most factory holes are predrilled
- Built for the 1987–1995 Wrangler YJ, driver side
Driver side fender preparation
Driver side front fenders take a lot of trail spray and road grime, so the surface often needs more prep than the mounting work. Start by cleaning the panel and sanding the black primer lightly, then apply a fresh primer coat if bare patches show. Paint should go on after the primer has cured, and the color should be checked against the hood and door panels in daylight.
Mounting goes faster when the old fender’s hardware is cleaned and inspected first. Threads and clips should turn freely, and any cracked bracket should be replaced rather than reused. Since most factory holes are predrilled, confirm alignment with the hood and headlight before tightening anything. Recheck the gap after the first few drives on rough ground.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 55013515 |
| UPC | 848399019599 |
| Material | Steel |
| Finish | Black primer coated |
| Position | Front left |
| Location | Driver side |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler (YJ) in the Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
It will not fit Renegade models, even though a Renegade trim is in the YJ range, so verify your trim before installing. It is for the YJ, separate from the TJ and LJ years, so match your model before buying.
Installation notes
Expect to prepare and paint the black primer coat before the fender is finished. Most factory holes are predrilled, so confirm alignment before drilling anything.
What’s included
One driver side (front left) steel fender, with no hardware or paint.
























