Overview
The Crown Automotive 55013514 is a replacement steel front fender for the passenger side (front right) of the 1987–1995 Jeep Wrangler YJ. It arrives black primer coated, so additional preparation is needed before painting.
Several YJ trims are covered, including Base, Islander, Laredo and Sahara. Renegade models are excluded, so read the vehicle fitment section before buying.
Key features
- Steel front right fender for the passenger side
- Black primer coated finish
- Most factory mounting holes are predrilled
- Built for the 1987–1995 Wrangler YJ, passenger side
Restoring a YJ front fender
YJ front fenders are exposed to salt, stones and years of trail use, so a replacement often comes with a restoration job. A black primer coat gives a starting surface, but it is not a finished paint. Plan to sand, clean and prime the fender before applying the final color. Check the inner lip of the fender for rust, since that area is hard to reach once the panel is mounted.
A YJ fender often works alongside a new grille, headlight bucket or hood latch, so inspect those parts while the front end is apart. Match the wheel well trim and bumper bracket to the panel before final tightening. Keep the old fender until the new one lines up, because a few mounting points may need cleaning or slight adjustment before the bolts seat fully.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 55013514 |
| UPC | 848399019582 |
| Material | Steel |
| Finish | Black primer coated |
| Position | Front right |
| Location | Passenger side |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler (YJ) in the Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
It will not fit Renegade models, even though a Renegade trim appears in the YJ range, so verify your trim before installing. It is for the YJ, separate from the TJ and LJ years, so match your model before buying.
Installation notes
The panel needs additional preparation before painting, so plan for sanding and paint as separate steps. Most factory holes are predrilled, but the fender may still need checking against the existing mounts before final fitting.
What’s included
One passenger side (front right) steel fender, with no hardware or paint.









