Overview
The Crown Automotive 83503593 is a rear driveshaft slip yoke for the front of the rear driveshaft on 1987–2001 Jeep Cherokee XJ models with two wheel drive and an automatic transmission.
A slip yoke lets the driveshaft change length as the drivetrain moves. This one is a direct fit for the Cherokee XJ from 1987 through 2001.
Key features
- Front of the rear driveshaft
- Two wheel drive with automatic transmission
- Direct fit for the Cherokee XJ
Driveshaft slip yoke basics
The slip yoke sits at the transmission end of the rear driveshaft and slides on the splines of the output shaft, allowing the shaft to lengthen and shorten as the axle moves over bumps and under power. Because it rides on splines, wear there shows up as vibration, a clunk on acceleration or a shaft that feels loose when pushed. Those are signs to inspect the yoke and the transmission output shaft together, since worn splines on either side produce similar symptoms.
When replacing a yoke, check the seal surface for scoring, since a worn seal lets fluid leak out. Inspect the universal joint at the other end of the shaft as well, because a worn joint sends the same vibration. Clean the splines and apply the correct driveshaft grease before assembly, and make sure the shaft slides freely before the yoke is torqued. Balance concerns can also appear after a driveshaft job, so check for vibration on the first drive.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83503593 |
| UPC | 848399025613 |
| Position | Front of the rear driveshaft |
| Drive | Two wheel drive |
| Transmission | Automatic |
Vehicle fitment
It fits the 1987–2001 Jeep Cherokee XJ, in its many XJ versions.
The list does not include the 1984–1986 Cherokee XJ, and the Grand Cherokee and Wrangler are not on it. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Rear driveshaft slip yoke.









