Overview
The Crown Automotive 52040112 is a stock replacement pitman arm for power steering on the 1987-1995 Jeep Wrangler (YJ).
The arm sits on the steering box output shaft, and its far end connects to the drag link. YJ owners usually replace it when the arm bends after a trail hit or when the shaft splines loosen.
It is a stock replacement, so the arm matches the original and does not correct drag link angle on a lifted Wrangler. A lifted YJ would need a dropped arm from a lift or steering maker instead.
The YJ’s square headlights and leaf springs are its recognizable features, and its steering arm is a common wear item on trail rigs.
A bent arm is easy to spot because the drag link sits at an odd angle and the steering wheel will not center. Trail damage and worn splines are the usual causes.
A stock arm is a good match for a YJ that still runs its original suspension height. A lifted YJ may benefit from a dropped arm, which is a different part and not the arm described here.
Key features
- Stock replacement arm for power steering
- Fits all 1987-1995 Wrangler YJ years
- Amount of drop: stock replacement
- Direct fit
- Crown Automotive Jeep replacement part
Steering geometry basics
The pitman arm converts the rotation of the steering box shaft into side-to-side motion that the drag link carries to the steering knuckle. Its length and angle set how the steering linkage moves through the wheel’s travel. When the arm bends, the drag link angle changes and the steering wheel may not center, which can make the vehicle pull or wander at speed.
Because the arm and drag link work together, a new arm is often checked alongside the drag link ends, tie rod ends and the steering box for play. Look for loose ball joints, torn boots and wear at the shaft splines before fitting a new arm, since worn parts will shift the new alignment. After installation, have the front end alignment checked so the steering wheel sits centered on a straight road.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52040112 |
| UPC | 848399014921 |
| Product type | Pitman arm |
| Amount of drop | Stock replacement |
| Steering type | Power steering |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the Crown Automotive 52040112 includes: 1987–1995 Jeep Wrangler (YJ) (Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara, Sport).
It fits only the Wrangler (YJ). The TJ, LJ and JK Wranglers and the CJ models are not covered. Match your vehicle’s year, model and trim before buying.
Installation notes
The old arm presses onto the steering box shaft, so a puller is needed to remove it. With the steering box centered, press on the replacement and tighten the nut, then check that the drag link end is secure.
What’s included
- One pitman arm, part number 52040112








