Overview
The Crown Automotive 52087883 is a manual steering pitman arm for the 1997-1998 Jeep Wrangler (TJ), sold as a stock replacement.
Manual steering TJs use a different steering gear from power steering models, and the pitman arm is matched to that gear. This arm is for manual steering, so a power steering TJ needs a power steering arm instead.
The arm has a stock replacement amount of drop. It restores original geometry and does not change drag link angle.
Many TJs came with power steering, so the manual steering arm is the less common part. Check the steering gear before ordering, since the two arms are not interchangeable.
Manual steering TJs are the less common version, so a manual arm is a narrower fit than the power steering arms. It fits the 1997 and 1998 model years only, so later TJs need a different arm.
A worn pitman arm often shows as slop in the steering wheel and uneven tire wear. Replacing it with the correct type restores the factory feel.
Key features
- Pitman arm for manual steering
- Fits 1997 and 1998 Wrangler TJ
- Stock replacement amount of drop
- Direct fit
- Not for power steering
Checking the steering linkage
The pitman arm moves the drag link, so any wear in the arm shows up as play at the steering wheel and as a loose feel on the road. Because the arm is pressed onto a splined shaft, a worn arm can work loose on the shaft, and a tight connection is needed for steering to hold its setting. Inspect the drag link and tie rod ends at the same time.
After a pitman arm is fitted, the steering box should be centered before the arm is set, and the steering wheel should sit straight when the front wheels point straight ahead. Check the drag link for play and confirm the steering moves freely from lock to lock before driving.
- Confirm the steering box is centered before fitting
- Check tie rod ends for play
- Tighten the nut to the value in the service manual
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52087883 |
| UPC | 848399015720 |
| Product type | Pitman arm |
| Amount of drop | Stock replacement |
| Steering type | Manual steering |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the Crown Automotive 52087883 includes: 1997–1998 Jeep Wrangler (TJ) (SE, Sahara, Sport).
Crown lists only the 1997-1998 Wrangler (TJ). TJ model years from 1999 to 2006 and the YJ Wrangler are not covered, and the arm is not for power steering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use a puller to take the old arm off the steering box shaft, since it is pressed on. With the steering box centered, fit the new arm, tighten the nut and check the drag link for play before driving.
What’s included
- One pitman arm, part number 52087883












