Overview
The Omix-ADA 18006.05 is a power steering pitman arm for the 1997–2006 Jeep Wrangler (TJ) and the 2004–2006 Wrangler Unlimited (LJ), made as a direct stock replacement with no drop.
The 18006.05 restores the factory steering arm rather than changing steering geometry for a lift. It is a direct OE replacement built to original specifications, with a limited five year warranty.
A pitman arm links the steering box to the drag link, and a worn or bent arm can leave steering loose or off-center. A Wrangler owner who needs to replace a factory arm and has a power steering box is the target buyer for this part.
A separate manual steering arm is made for the TJ, so confirm the steering type before choosing. This arm is for the power steering box.
The listed trims run from the 65th Anniversary Edition through Rubicon, SE, Sahara, Sport and X, plus Unlimited and Unlimited Rubicon for the LJ.
Key features
- Power steering pitman arm
- Direct OE replacement built to original specifications
- Stock replacement with no drop
- Direct fit
- Covers both TJ and LJ Wranglers
- Limited five year warranty on this part
Steering arm wear and checks
The pitman arm takes the steering box output and moves the drag link, so any play at the arm is passed directly to the front wheels. Wear often shows up as a wandering feel on the highway, a steering wheel that sits off center, or a clunk when turning at low speed. Inspect the arm, the nut and the ball joint on the drag link for looseness before deciding whether the arm needs replacing.
Replacing a pitman arm can change steering center, so the job is best finished with a steering and alignment check. Clean the tapered shaft and check the splines for wear before fitting the new arm, and tighten the nut to the correct torque for the steering box. Re-check the drag link and steering damper after the first drive, since a loose link can cause the same symptoms as a worn arm.
- Check the drag link for play
- Verify steering center after the job
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18006.05 |
| UPC | 804314052263 |
| Product type | Power steering pitman arm |
| Amount of drop | Stock replacement |
| Fit type | Direct fit |
| Steering type | Power steering |
| Warranty | Coverage is limited and runs five years. |
Vehicle fitment
The 18006.05 fits two Wrangler generations. The Unlimited LJ is included alongside the TJ, with the trims shown below.
- 2004–2006 Jeep Wrangler (LJ) (Unlimited, Unlimited Rubicon)
- 1997–2006 Jeep Wrangler (TJ) (65th Anniversary Edition, Rubicon, SE, Sahara, Sport, X)
The earlier YJ and the 2007 and newer JK are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
It fits without modification. Use the torque value for your steering box and pitman nut, and have a qualified technician check the steering after replacement.
What’s included
One power steering pitman arm. Check the package for a nut or washer before starting, and have the correct hardware on hand.














