Overview
The Crown Automotive J3236434 is a brake hose washer that seals the brake hose where it connects to the caliper at the front. It fits a range of Jeep models from the early 1980s through the 2000s.
Key features
- Brake hose washer
- Used where the brake hose meets the caliper
- Front position
- Direct-fit replacement
Before you replace the washer
Brake hose washers are small sealing rings that sit between the end of a brake hose and the caliper fitting. When the banjo bolt is tightened, the washer compresses and forms a seal that keeps brake fluid inside the system. Because the seal depends on the ring deforming to the fitting, it is normally a single-use part.
When the hose is disconnected for caliper service, pad work or a hose swap, discard the old washer rather than reusing it. Inspect the hose end and caliper fitting for damage, and look for weeping fluid around the joint after the system is refilled. Once the hose is back on, bleed the brakes so no air remains in the lines.
- Discard the old washer whenever the banjo bolt comes out
- Clean the caliper fitting and hose end before assembly
- Check for fluid seepage after the first firm pedal test
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3236434 |
| UPC | 848399060782 |
| Part type | Brake hose washer |
| Function | Brake hose to caliper |
| Position | Front |
| Fit | Direct fit |
Vehicle fitment
The J3236434 washer fits the 1984–2001 Jeep Cherokee (XJ), the 1982–1983 CJ5, the 1982–1986 CJ7, the 2006–2010 Commander (XK), the 2005 Grand Cherokee (WJ), the 2006–2010 Grand Cherokee (WK), the 2003–2005 Liberty (KJ), the 1982–1985 Scrambler, the 1997–2006 Wrangler (TJ) and the 1987–1995 Wrangler (YJ).
The Wrangler JK and LJ are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A washer at the caliper connection should be replaced whenever the hose is removed, followed by a brake bleed.









