Overview
The Crown Automotive J4004110 is a left exhaust manifold stud for Jeep vehicles with 5.0L-304, 5.9L-360 or 6.6L-401 V8 engines. It is a direct-fit replacement for older CJ, SJ and J-series Jeeps.
Exhaust manifold studs hold the manifold to the cylinder head, so the correct side and fitment matter for a proper seal. Fitment runs from 1972 through 1991, as shown in the Vehicle fitment section below.
Key features
- Left-side stud for the exhaust manifold
- It is a direct-fit replacement for the older stock stud.
- Fits 5.0L-304, 5.9L-360 and 6.6L-401 V8 engines
- Two are required per application.
Before you install
Exhaust manifold studs take repeated heat cycles, so the threads and the seat at the cylinder head carry most of the load. Before fitting a new stud, clean the threaded hole and check it for damage, crossed threads or debris. A clean hole lets the stud seat fully and lets the nut tighten evenly against the manifold flange.
Look closely at the old stud as well. Stretching, rust near the base or stripped threads are signs it should be replaced rather than reused. Once the engine has run through a few heat cycles, recheck the nuts, since the joint settles as the metal expands and cools.
- Inspect the old stud for stretching, rust or stripped threads
- Clean the threaded hole and remove any debris
- Tighten nuts in a crisscross pattern
- Recheck the nuts after the first few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J4004110 |
| Alternate part number | CROJ4004110 |
| Position | Left |
| Quantity | 2 required |
| Engine applications | 5.0L-304, 5.9L-360 and 6.6L-401 V8 |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1983 Jeep Cherokee (Wide Track Chief); 1974–1983 Jeep Cherokee (SJ) (Base, Chief, Pioneer, S, Wide Track); 1972–1981 Jeep CJ5 (Base, Golden Eagle, Laredo, Renegade); 1972–1975 Jeep CJ6 (Base); 1976–1981 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Renegade); 1972–1973 Jeep Commando (Base); 1984–1991 Jeep Grand Wagoneer (SJ) (Base, Limited); 1972–1973 Jeep J-2500, J-2600, J-4500, J-4600, J-4700 and J-4800 (Base); 1974–1988 Jeep J10 and J20 (Base); and 1972–1983 Jeep Wagoneer (SJ) (Base, Brougham, Custom, Limited).
Models and years outside this list, such as Grand Wagoneer after 1991 or J10 and J20 after 1988, are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The quantity is 2 required for this left stud.
Not included: Verify hardware and gaskets against your installation before starting.









