Overview
The Crown Automotive exhaust clamp, part number CRO630534, is a 1-1/2 inch clamp for the muffler-to-tailpipe connection. It is a direct fit for several Jeep CJ and Willys models.
It fits 1959-1983 Jeep CJ5 models, a 1979 Jeep CJ7 Base, and Willys CJ-2, CJ-3 and CJ-5 models from 1946 to 1958. Confirm your vehicle’s year, model and trim before ordering.
Key features
- 1-1/2 inch clamp size
- Designed for the muffler-to-tailpipe connection
- Fits Jeep CJ and Willys models
- Part number CRO630534
Clamp fit and tightening
An exhaust clamp holds two pipe ends together and seals the joint with a band that tightens around them. A clamp that is too small or too large for the pipe will leak at the joint or fail under heat and vibration. Measure the pipe diameter at the joint where the clamp sits, and check that the pipe ends are round and free of heavy dents before installing.
Tighten the clamp evenly, a little at a time, so the band seats across the full joint rather than pulling to one side. Alignment matters as much as tightness: the pipe should slide into the clamp square and sit without strain on the mounts. Old clamps can crack from heat cycling, so replace any that show rust, flattening or cracking when the system is opened.
- Check the pipe for dents at the joint
- Tighten the clamp evenly across the joint
- Confirm the pipe sits without strain
- Recheck the clamp after the first warm-up
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | CRO630534 |
| Part type | Exhaust clamp |
| Position | Muffler to tailpipe |
| Clamp size | 1-1/2 inch |
| Fitment type | Direct fit |
Vehicle fitment
The manufacturer fitment list covers 1959-1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade), 1979 Jeep CJ7 (Base), 1946-1949 Willys CJ-2, 1949-1953 Willys CJ-3 and 1955-1958 Willys CJ-5.
The list includes only the 1979 CJ7 year and no Wrangler, Cherokee or Grand Cherokee models. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents for hardware before installing, since clamps and bolts may need to be sourced separately.









