Overview
The Crown Automotive J0911467 is a clutch bellcrank measuring 8-1/8 inch long, with 5-3/4 inch between the brackets. It fits the 1957–1964 Jeep FC150 in base trim.
In a mechanical clutch linkage, the bellcrank changes the direction of pedal travel between the rods and the cable, which is why the bracket spacing matters when comparing parts.
Key features
- Clutch bellcrank 8-1/8 inch long
- 5-3/4 inch between brackets
- Direct fit for the 1957–1964 Jeep FC150.
- Crown Automotive part number J0911467
Before you buy
A clutch bellcrank sits in the middle of the linkage and converts pedal travel into a push or pull on the release cable or rod. Because it swings through a fixed arc, its bushings and pivot points wear over time, and play at the bellcrank often shows up first as a clutch that engages high in the pedal travel.
Before ordering, measure the old unit’s length and bracket spacing against the figures given above so the replacement lines up with the existing linkage. When the bellcrank is replaced, it is common to inspect the pedal pivot, the clevis pins and the return spring during the same job, since worn pins or a stretched spring can mimic a failed bellcrank.
- Measure the old bellcrank’s length and bracket spacing
- Inspect pedal pivot bushings and clevis pins
- Check the return spring for stretching
- Confirm free movement before road testing
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0911467 |
| Length | 8-1/8 inch |
| Bracket spacing | 5-3/4 inch between brackets |
| Fitment type | Direct fit |
Vehicle fitment
This bellcrank fits the 1957–1964 Jeep FC150 in Base trim.
Other Jeep models and FC150 years outside that range are not in this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The item is the clutch bellcrank listed under part number J0911467.









