Overview
The Centerforce N1716 is a flat face throwout bearing, the clutch release bearing that the release fork pushes to disengage the clutch. It fits Chevrolet and GMC trucks, SUVs and vans from 1983 through 1995, including Astro, Blazer, S10, Jimmy, Safari, Savana, Sonoma, Tahoe, Yukon and the C, K, R and V series pickups.
The bearing is made to withstand the wear of racing clutch use and to give reliable service on the track and long life on the street.
Key features
- Flat face design
- Built for the wear of racing clutch use
- Reliable service for track and street use
- Longevity for street use
- Fitment marked as direct fit
Release bearing wear and replacement
The throwout bearing rides against the fingers of the pressure plate and moves whenever the clutch pedal is pressed. Over time it can wear, dry out or become noisy. Noise when the pedal is pressed, a rough or grabbing pedal feel, and a clutch that does not fully release are common signs it needs attention.
Replacing the bearing is usually done alongside the clutch disc and pressure plate, since the release system wears with the friction parts. Check the release fork, pivot and sleeve for wear while the transmission is out. A bearing that is seated squarely and moves freely on the sleeve helps the clutch disengage cleanly.
- Replace worn bearings with the clutch
- Inspect the release fork for cracks
- Clean the transmission sleeve before fitting
- Confirm the bearing moves freely on the sleeve
Specifications
| Brand | Centerforce |
|---|---|
| Part number | N1716 |
| Face type | Flat face |
| Fitment years | 1983–1995 |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1983–1995 Chevrolet and GMC C, K, R and V series pickups and their Suburban versions, Chevrolet Astro and Blazer, S10 and S10 Blazer, Jimmy, Safari, Sonoma, Savana, Yukon, and the 1995 Chevrolet Tahoe.
Jeep, Dodge and Ford models and years after 1995 are outside this fit. Verify the year, make and model against this range before purchase.
What’s included
The bearing is sold alone. Check the release fork and sleeve against your installation before starting.









