Overview
The Body Armor 4×4 Cube Flood LED Light, part number B/A30041, is a set of two cube-shaped LED flood lights for Jeeps, trucks and SUVs. Each light is rated at 40 watts and 5000 lumens, and the flood beam spreads light over a wide area close to the vehicle.
Body Armor 4×4 began as a weekend Jeep enthusiast’s project to build bumpers that fit well. The cube lights belong to the company’s accessory line, alongside its exterior armor, racks, interior storage and suspension parts.
A flood beam suits close-range work, such as lighting a camp area or the ground around a rig at night, while spreading light to the sides of the vehicle.
Key features
- Cube-shaped LED light pods sold as a set of two
- Flood beam pattern
- 40 watts and 5000 lumens per light.
- LED light source
Placement and load planning
A flood beam spreads light across a wide area near the vehicle, which makes placement a question of coverage more than reach. Mounting the pair low and angled slightly down lights the ground beside the rig, while higher mounting spreads light farther out. Think about the work you do most, such as setting up camp, loading gear or checking a rock step, and place the lights to cover that spot.
Because the pair runs from one switch, the wiring has to carry the combined load of both lights. Use a fuse and relay sized for the full draw, and route the cable so it is protected from heat, water and moving parts. Keep the lens clear of mud and check the seals after washing, since a flood light is often used in the wet and dust that trail work brings.
- Aim low for ground coverage near the vehicle
- Wire both lights to one fused switch
- Clean lenses after mud and washing
Specifications
| Brand | Body Armor 4×4 |
|---|---|
| Part number | B/A30041 |
| Light type | LED light pod |
| Quantity | Set of 2 |
| Beam pattern | Flood |
| Watts | 40 per light |
| Lumens | 5000 per light |
| Bulb type | LED |
Vehicle fitment
The cube flood lights are a universal fit, so they are not made for one vehicle. Mounting is the owner’s choice, so check the placement on the vehicle before drilling or applying any mounting hardware.
Confirm the mounting surface and wiring route on your own vehicle before installing.
Installation notes
Wire the pair through a fused circuit with a switch. At 40 watts per light, the pair draws a meaningful load, so size the fuse and relay to the setup. Check local rules on auxiliary lighting before using the lights on a road vehicle.
What’s included
The set contains two cube flood LED lights. Check the package contents for a harness, switch and mounting hardware before starting.
The set includes two lights, so the pair can be mounted symmetrically and run from one switch. Each light is rated at 40 watts and 5000 lumens, so plan the wiring for the combined load of both.














