Overview
The Bilstein 24-186513 is a front 5100 Series monotube gas charged shock absorber with an 8.25 in. travel length. It fits the 1980 to 1996 Ford Bronco and the 1980 to 1996 Ford F-150, with a rated lift of w/4 in. lift.
Bilstein designed the 5100 Series for lifted trucks, Jeeps and prerunners. The single tube gas pressure body is meant to hold steady damping over long use, and the shock uses a non-coilover body with the stock OEM mounting configuration for the lift kits it was matched to.
Key features
- Monotube gas pressure construction
- Self-adjusting deflecting disc valving
- High-flow piston that Bilstein says reduces harshness
- Independent rebound and compression tuning
- Larger working piston area for controlled damping
- Boot included
Front end considerations
The front shock works with the steering knuckle, the control arms and the spring, so its load changes with every turn and bump. On an older truck, the original shocks often have worn bushings and leaking seals, which can make the front end wander or float. Replacing the shock is a good moment to inspect the whole front end, since a worn joint can make a new shock feel like it is not doing its job.
Because this model uses a stem upper mount and a 16mm eye lower mount, check that the bracket on your truck is straight and free of cracks before bolting the new unit in. When choosing lift height, keep the front shock within its rated range so it does not reach the end of its stroke on the bump stops. Gas-charged shocks should be handled with care and serviced only by a shop with suitable equipment.
- Inspect upper and lower brackets for cracks
- Check steering joints and tie rod ends for play
- Replace front shocks in pairs for even steering
- Confirm the rated lift before installing
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-186513 |
| UPC | 651860592565 |
| Series | 5100 Series |
| Position | Front |
| Collapsed length | 13.27 in. |
| Extended length | 21.52 in. |
| Travel length | 8.25 in. |
| Lower mount | Eye, 16mm |
| Upper mount | Stem |
| Shaft diameter | 14mm |
| Body design | 46mm ID smooth body, non-coilover |
| Internal design | Monotube |
| Gas charged | Yes |
| Reservoir | No |
| Finish | Zinc plated |
| Boot | Included |
| Lift height rating | w/4 in. lift |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1980 to 1996 Ford Bronco in the Custom, Eddie Bauer, Ranger XLT, XL, XLS, XLT, XLT Lariat, XLT Nite and XLT Sport trims, and the 1980 to 1996 Ford F-150 in the Base, Custom, Eddie Bauer, Ranger, Ranger Lariat, Ranger XLT, Special, XL, XLS, XLT and XLT Lariat trims.
Model years outside 1980 to 1996 and later Ford F-150 and Super Duty models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rated lift is w/4 in. lift, so check that your truck’s height falls within that range before fitting this front shock. Support the front end on stands and never work under a vehicle held only by a jack.
What’s included
One Bilstein 5100 Series front shock absorber with its boot.









