Overview
The Baer Brakes 4262258B is a rear SS4 Plus brake system for Ford 8.8 inch C-clip rear ends with a 2.5 inch axle standoff and a 5 lug wheel pattern of 5×4.50. It combines a black S4 four-piston caliper with a 13 inch, two-piece slotted, drilled and zinc-plated rotor that uses a billet aluminum hat.
Baer designed the SS4 Plus for owners who want a larger rear brake package than a stock Ford 8.8 setup usually carries. The rotors arrive pre-assembled with NAS high grade stainless hardware, and stainless braided hoses are part of the kit. A one-piece park brake shoe assembly sits inside the backing plate, which also serves as the caliper mount. Lug nuts and park brake cables are not included, so they must be obtained separately before installation.
Key features
- Black S4 four-piston caliper with a floating design
- Two-piece slotted, drilled and zinc-plated rotor with a billet aluminum hat
- One-piece park brake shoe assembly housed in the backing plate
- Dual seals that guard against dust, weather and pressure
- Hard anodized aluminum pistons with stainless steel abutments and noise suppression clips
- Stainless braided hoses and pre-assembled stainless rotor hardware
Brake pads and rotor care
Rear brake pads are the wear part in a kit like this, and their friction material should be checked at every brake service. Pads worn down to the backing material can score the rotor face, so replace them before that damage starts. Stay with the DR1-C pad type this kit uses so the friction and fit match the caliper.
Two-piece rotors with an aluminum hat can be pulled and inspected without disturbing the caliper. Check the hat fasteners for looseness and the rotor for heat cracking. Heavy towing and repeated hard stops raise rotor temperature, so inspect more often in those conditions. Keep the rotor surface free of grease and clean it before the pads go in.
- Check pad thickness at every service
- Inspect hat fasteners after the first few trail runs
- Look for heat cracks and deep grooves on the rotor
- Replace braided hoses that show chafing or bulging
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 4262258B |
| UPC | 844165028192 |
| Caliper | S4, four-piston, floating, black |
| Rotor outside diameter | 13.0 inch |
| Rotor thickness | 0.81 |
| Rotor type | Two-piece, vented, iron with aluminum hat |
| Rotor surface | Slotted, drilled and zinc plated |
| Pad type (FMSI) | DR1-C |
| Lug count | 5 lug |
| Wheel bolt pattern | 5×4.50 |
| Axle flange | Ford 8.8 inch |
| Minimum wheel diameter | 17.0 inch |
| Hose material | Steel braided |
| Park brake | Included |
| Template | S135H |
| Country of origin | US |
Vehicle fitment
It is built for Ford 8.8 inch rear axles with a Ford axle flange, a 2.5 inch axle standoff and a 5×4.50 bolt pattern. Match those measurements to your axle and wheels before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The rotors are pre-assembled, so no separate rotor assembly with hardware is needed. The SS4 Plus suits wheels 17 inch or larger, so compare the S135H template with the wheel you plan to run. Bleed the hydraulic lines, then test the pedal and park brake before driving.
What’s included
The kit includes the S4 caliper, two-piece 13 inch rotors, the park brake shoe assembly, stainless braided hoses and stainless hardware.
Not included: Park brake cables and lug nuts must be obtained separately.















