Overview
The Baer Brakes 6920962 is a 15 inch, 1-piece slotted, drilled and zinc-plated replacement rotor for the right side of select Baer Brake systems. It is 1.18 inch thick, with six lug holes on a 5.50 inch bolt circle and a 3.094 inch center register, so check those dimensions against your hub before ordering.
It is a single full-cast piece with no drum in the hat. The rotor is directional and specific to one side, and its overall height is 2.177. Vehicle makes, models and years are unknown for part number 6920962, so confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Slotted, drilled and zinc-plated braking surface.
- Full cast, one-piece construction.
- Directional right-side design, matched to one side of the vehicle.
- Curved vanes, which Baer says support cooling.
- Dynamic balanced for vibration-free running.
Register and hub fit
A center register locates the rotor on the hub so the lug studs carry the load rather than the bolt holes taking the strain. Before mounting, clean the hub face and remove any rust or old debris that could hold the rotor off true. A rotor that sits crooked will show as pedal pulsing even when the surface is new.
One-piece full-cast rotors are heavier than many two-piece designs and carry the whole braking surface in one casting. Inspect the hat and braking face for cracks, deep grooves or a blue tint from overheating. Drilled and slotted faces can wear pads faster, so pick a compound designed for that surface and check pad wear at each service.
- Measure runout before and after mounting
- Torque lug nuts in a star pattern
- Re-check the lug nuts after the first few drives
- Replace the rotor when it reaches its minimum thickness
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6920962 |
| UPC | 844165037422 |
| Outside diameter | 15 inch |
| Nominal thickness | 1.18 inch |
| Stud/lug hole quantity | 6 |
| Stud/lug hole circle diameter | 5.50 inch |
| Center hole diameter (register) | 3.094 inch |
| Overall height | 2.177 |
| Construction | Full cast, one piece |
| Rotor type | Vented |
| Brake surface | Directional |
| Axle | Right |
| Surface type | Slotted, drilled and zinc plated |
| Material | Cast iron |
| Grade type | Performance |
| Drum in hat | No |
| ABS tone ring included | No |
| Emission code | 6 |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
Fitment is unknown for the Baer Brakes 6920962. It is designed for select Baer Brake systems, so confirm fit for your vehicle’s year, model and trim before ordering.
This is a right-side rotor and is not made for the left. Confirm the 6-hole, 5.50 inch pattern and the 3.094 inch register against your hub. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The 3.094 inch center register must seat correctly on your hub, so check the fit before mounting. Match the right-axle designation to the right side of your Baer system. Have a qualified technician verify the installation, including the slotted face, before the vehicle is driven.
What’s included
One 1-piece slotted, drilled and zinc-plated rotor, sold individually.
Not included: ABS tone ring, pads, calipers and other brake hardware.
