Overview
The ARB OMEGP7 is a rear shackle and pin kit from ARB 4×4 Accessories, built around a greaseable pin design. The assembly bolts together and is meant to avoid out-of-angle pin to side plate issues.
It carries a direct fit label without a year, make, model or trim attached. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Rear position shackle kit
- Bolt-together assembly
- Two grease outlet holes in each shackle pin
- Direct fit label, with no vehicles named
Choosing and maintaining a shackle kit
A rear shackle kit sits at the end of the leaf spring and lets the spring change length as the axle moves over bumps. Worn or bent shackles can cause the axle to wander, knock or ride unevenly, so a shackle and pin kit is often replaced when the old pins are seized, the bushings are cracked, or the shackle plates show elongated holes. Before buying, measure your current shackle center distance and pin diameter so the replacement lines up with the spring eye and frame hanger.
Greasing matters most on a kit with greaseable pins. Grease the pins at the interval your use calls for, typically after washdowns or water crossings, and wipe off old grease before adding new so dirt does not get pushed into the bearing surface. Check the shackle plates and pins for play by hand every few trail outings, and re-torque the fasteners after the first few runs on a new install.
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | OMEGP7 |
| UPC | 70000344163 |
| Position | Rear |
| Component | Shackle and pin kit |
| Grease outlet holes | Two per pin |
| Assembly | Bolt together |
| Fitment | Direct fit, no vehicles named |
Vehicle fitment
No year, make, model or trim is named for OMEGP7, so the kit is not confirmed for any specific vehicle.
A direct fit label does not replace checking your rear spring and shackle mounts. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Grease each pin through its two outlet holes after the kit is bolted together. Support the rear axle and leaf spring securely before removing the original shackles.
What’s included
The kit is sold as a rear shackle and pin set under OMEGP7. Check the package contents against your installation before starting.









