Overview
The ARB RD81 is a pneumatic air locking differential for the rear Ford 8.8 inch axle with 31 splines. Compressed air locks both axles together, turning an open differential into a full spool so both wheels receive drive power when traction runs out.
The RD81 is a selectable locker, so the driver can engage it when the trail calls for it. Running it needs air from an ARB onboard compressor. The axle is Ford 8.8 Inches with a rear location. Because an air locker must match the axle it goes into, check the axle housing before ordering.
Key features
- Pneumatic operation locks both axle shafts on demand
- Converts an open differential to a full spool for 100% power to both wheels
- Selectable locker type
- 31 spline axle fit for Ford 8.8 inch rear axles
- Operation needs an onboard compressor from ARB
Gear and axle care
A locker changes how torque moves through the axle, so the ring and pinion and the spider gears see different loads once it is engaged. Use the locker in controlled situations and avoid locking it on dry pavement, where the axle can bind during turns. Regular gear oil checks and the correct lubricant keep the gears protected under heavier use.
Axle seals and bearings also carry more load when a locker is in use. Look for seepage at the pinion seal and axle tubes, and listen for whining or clunking that changes with speed. Replacing worn parts during the installation is usually easier than doing it later on the trail.
- Check gear oil level and condition
- Inspect pinion and axle seals
- Listen for new whining or clunking noises
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | RD81 |
| UPC | 837290004766 |
| Locker type | Pneumatic, selectable |
| Axle manufacturer | Ford |
| Axle type | Ford 8.8 Inches |
| Axle location | Rear |
| Axle spline count | 31 splines |
Vehicle fitment
Fit is by axle: a rear Ford 8.8 inch axle with 31 splines. Identify your axle and its spline count before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fitting an air locker means opening the axle, so an experienced axle shop should handle the teardown and gear setup. Plan the air line route first so it stays clear of suspension and driveline parts.
What’s included
The package is the locker only. Check the package contents against your installation before starting. Not included: the ARB onboard air compressor, which is required to operate the locker and is sold separately.









