Overview
The ARB RD172 is a Dana 70/80 selectable locker with 35 splines and 4.56 up gearing. It is an Eaton E-Locker that switches from open to spool with an electronic push button and runs on 12 volt power. Confirm the locker type before installing it.
This unit is electronic, so a 12 volt electrical supply is the main setup item rather than a compressor. Wire it to a fused 12 volt supply and confirm the connections before first use.
Key features
- Electronic push button selectable locker
- Moves from open to spool with the press of a button
- No air lines to leak or snag
- Requires 12 volt power
- Built for 35 spline axles
- Listed gearing: 4.56 up
Electronic locker wiring
Electronic lockers use a switch and a solenoid rather than an air line. Wiring is the main job: a fused 12 volt feed, a solid ground and a switch placed where it can be reached without looking. Route the harness away from heat, moving suspension parts and the exhaust, and secure it with clips so it does not snag on rocks.
A fault in the electrical path can keep the locker from engaging even when the unit itself is sound. Check the fuse and ground first, then the switch and connectors. Keep a spare fuse and a few connectors in the kit, and recheck the wiring after the first few trail runs.
- Use a fuse rated for the circuit
- Clean and tighten the ground connection
- Seal connectors against water and mud
- Check the harness after rough trail use
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | RD172 |
| UPC | 9332018003379 |
| Differential type | Selectable locker, electronic (per description) |
| Power | 12 volt |
| Axle manufacturer | Dana |
| Axle type | Dana 70/80 |
| Axle spline count | 35 splines |
| Gear ratio | 4.56 up |
Vehicle fitment
Fit depends on the axle: a Dana 70 or Dana 80 housing with 35 splines and 4.56 up gearing. Confirm the housing and spline count against your axle.
Other spline counts and gear ratios are not covered by these specifications. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Wiring a 12 volt supply is the setup step for this unit, so route power as the manufacturer directs and fuse the circuit. An electrical fault can prevent the locker from engaging.
What’s included
Included: the RD172 locking differential.
Not included: A 12 volt power supply, which the locker requires.








