Overview
The ARB RD93 is a pneumatic air locking differential for the Chrysler 8.25 inch rear axle, with 29 splines. Compressed air engages the locker, so both axle shafts turn together and the rear axle delivers equal drive when traction is poor.
The RD93 is a selectable locker that turns an open differential into a full spool, supplying 100% power to both wheels when engaged. It needs an ARB onboard compressor, sold separately. Match the axle size and spline count to your rear axle before ordering.
Key features
- Pneumatic, air-actuated locking
- Converts an open differential to a full spool
- Supplies 100% power to both wheels when engaged
- Selectable locker type
- 29 spline axle fit for a Chrysler 8.25 inch rear axle
Gear setup and installation work
Installing a locker is a gear-level job that goes beyond swapping a part. The differential case is removed, the locker is set into the carrier, and the ring and pinion must be set up for proper mesh and backlash. A shop with the right gauges and a clear procedure will avoid noise and early wear, which is why the work is best left to a qualified team.
After the install, check the gear oil level and look for leaks at the cover and pinion seal. Listen for clunks or a chatter through turns during the first drives, since these can signal a setup or fitting issue. Keep the air system dry and the compressor filter clean, and recheck the hardware after the first few trail runs.
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | RD93 |
| UPC | 837290004858 |
| Locker type | Pneumatic, selectable |
| Axle manufacturer | Chrysler |
| Axle type | Chrysler 8.25 Inches |
| Axle location | Rear |
| Axle spline count | 29 splines |
Vehicle fitment
No vehicle is named with years or a chassis code. The RD93 is for the Chrysler 8.25 inch rear axle with 29 splines, so compare your rear axle’s size and spline count before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a differential is a major axle job, so have a qualified shop open the axle, install the locker and set up the gear mesh. Route the air line away from heat sources and moving parts.
What’s included
Not included: The ARB onboard compressor needed for operation, which is a separate purchase.







