Overview
The Alloy USA bearing retainer, part number 16536.11, is a rear axle bearing retainer built for the DANA 35 axle. Alloy USA gives the rear position and the DANA 35 axle type as the application for this part.
A bearing retainer holds the axle shaft bearing in the axle housing, so the correct axle type matters before installation. It is a direct fit axle part for the DANA 35 rear axle. Confirm fit for your vehicle’s year, model and trim before ordering.
Axle type and retainer care
A bearing retainer is the plate or ring that holds the axle shaft bearing in place inside the axle housing, and it keeps the bearing from walking out under load. Because retainers are built for particular axle housings, the housing type and bearing size should be confirmed before any work begins. A retainer that is cracked, bent or loose in its bore should be replaced rather than reused.
During a rear axle rebuild, the retainer is typically removed with the axle shaft and bearing, so new gasket material, seals and bearing parts are commonly replaced in the same job. Clean the housing bore thoroughly and check for scoring before installing. Use the fastener torque from your service manual and check for lubricant seepage after the first few drives.
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 16536.11 |
| UPC | 804314176723 |
| Position | Rear |
| Axle | DANA 35 |
Vehicle fitment
It fits the DANA 35 rear axle. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.









