Overview
The Omix-Ada 16536.38 is an axle shaft retainer plate for the rear Dana 44 axle. It fits the 1988–1995 Jeep Wrangler (YJ).
It replaces the original plate and is built to the original specifications.
Key features
- Retainer plate for the rear Dana 44 axle
- Direct OE replacement for the stock plate.
- Fits the Wrangler YJ
- UPC 804314062316
Retainer plate maintenance
A retainer plate sits at the axle end and holds the axle shaft in position, so its condition affects how the shaft stays put under load. A cracked or bent plate can let the shaft work loose, and an uneven plate makes the seal leak. Look at the plate whenever the axle is opened, since plates often come off during axle work.
Clean the mating surfaces before reinstalling the plate, and check the bolt holes for wear. Replace the gasket or sealant as needed, and use new fasteners if the old ones look stretched. Tighten the bolts evenly so the plate seats flat against the housing.
- Cracks or bends in the plate
- Worn or elongated bolt holes
- Uneven seating against the housing
- Oil weeping at the plate edge
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16536.38 |
| UPC | 804314062316 |
| Axle | Rear Dana 44 |
Vehicle fitment
It fits the 1988–1995 Jeep Wrangler (YJ) in the Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
Wrangler TJ and JL models and Wrangler YJ years outside 1988–1995 are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One retainer plate.









