Overview
The Crown Automotive 83504190 is a seal retainer for the Model 44 rear axle. It fits Jeep Cherokee (XJ), CJ7, Comanche and Wrangler (YJ) models from 1986 to 1995.
It is for the Model 44 rear axle.
Key features
- Seal retainer for the Model 44 rear axle
- Fits four Jeep model ranges
- Crown Automotive part number 83504190
Seal retainer care
A seal retainer holds the axle seal in its bore and keeps the seal square to the shaft. If the retainer bore is worn or the seal sits crooked, oil escapes at the seal lip even when the seal is new. Check the bore for wear, burrs and corrosion whenever the seal is replaced.
Because the retainer is part of the axle assembly, it is often removed while other axle work is done. Clean the mating surface before installing it and use fresh gasket or sealant as the design requires. Tighten fasteners evenly and recheck for leaks after a few drives. Oil in the wheel area after a service suggests the retainer or seal needs another look.
- Clean the mating surface before reinstalling
- Check the seal bore for burrs or corrosion
- Recheck for leaks after the first drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83504190 |
| UPC | 848399025880 |
| Axle | Model 44 rear |
Vehicle fitment
It fits the 1987–1990 Jeep Cherokee (XJ), the 1986 Jeep CJ7, the 1986–1992 Jeep Comanche and the 1988–1995 Jeep Wrangler (YJ), across the trims covered for each.
Years outside these four ranges and the Wrangler TJ are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One seal retainer. Check the package contents against your installation before starting.









