Overview
The Crown Automotive J0636344 is a retaining nut for Dana 44 rear axle shafts. It is a rear axle part, and Crown Automotive presents it as a direct fit replacement for Jeep vehicles.
The Dana 44 rear axle is the main compatibility check, so match the nut to that axle before fitting.
Key features
- Retaining nut for rear axle shafts
- Dana 44 axle application
- Rear position
- Direct Fit label
Rear axle shaft retention
The axle shaft nut holds the shaft in place at the hub or flange, so it carries load every time the vehicle moves. On rear axles, the nut works with the bearing and retainer to keep the shaft from walking out of position. A nut that loosens can allow the shaft to shift, which may lead to noise, vibration or further damage to the axle assembly.
Before reusing a nut, inspect the threads for stretching, nicks or corrosion, and check the seating face for damage. Retaining hardware is often replaced during axle service, especially when the bearing or seal is changed. Tighten to the specification in your service information and recheck after the first trail runs to confirm nothing has backed off.
- Check threads for stretching or nicks
- Recheck tightness after the first few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0636344 |
| UPC | 848399051766 |
| Position | Rear |
| Axle application | Dana 44 |
| Fitment label | Direct Fit |
Vehicle fitment
Vehicle years, models and trims are not confirmed for this nut. Compatibility rests on the Dana 44 rear axle application.
Match the nut to your rear axle before fitting it. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the number of nuts and any washers against your installation before starting.














